mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2024-09-05 18:39:59 +00:00
dt/misc: add bindings documentation for ifm camera sensor interface
IFM O2D cameras use special sensor bus interface glue-logic to connect camera sensors to mpc5200 LocalPlus bus. Add device tree bindings documentation for it. Signed-off-by: Anatolij Gustschin <agust@denx.de>
This commit is contained in:
parent
56ebc06393
commit
00e4b1975b
1 changed files with 41 additions and 0 deletions
41
Documentation/devicetree/bindings/misc/ifm-csi.txt
Normal file
41
Documentation/devicetree/bindings/misc/ifm-csi.txt
Normal file
|
@ -0,0 +1,41 @@
|
|||
IFM camera sensor interface on mpc5200 LocalPlus bus
|
||||
|
||||
Required properties:
|
||||
- compatible: "ifm,o2d-csi"
|
||||
- reg: specifies sensor chip select number and associated address range
|
||||
- interrupts: external interrupt line number and interrupt sense mode
|
||||
of the interrupt line signaling frame valid events
|
||||
- gpios: three gpio-specifiers for "capture", "reset" and "master enable"
|
||||
GPIOs (strictly in this order).
|
||||
- ifm,csi-clk-handle: the phandle to a node in the DT describing the sensor
|
||||
clock generator. This node is usually a general purpose timer controller.
|
||||
- ifm,csi-addr-bus-width: address bus width (valid values are 16, 24, 25)
|
||||
- ifm,csi-data-bus-width: data bus width (valid values are 8 and 16)
|
||||
- ifm,csi-wait-cycles: sensor bus wait cycles
|
||||
|
||||
Optional properties:
|
||||
- ifm,csi-byte-swap: if this property is present, the byte swapping on
|
||||
the bus will be enabled.
|
||||
|
||||
Example:
|
||||
|
||||
csi@3,0 {
|
||||
compatible = "ifm,o2d-csi";
|
||||
reg = <3 0 0x00100000>; /* CS 3, 1 MiB range */
|
||||
interrupts = <1 1 2>; /* IRQ1, edge falling */
|
||||
|
||||
ifm,csi-clk-handle = <&timer7>;
|
||||
gpios = <&gpio_simple 23 0 /* image_capture */
|
||||
&gpio_simple 26 0 /* image_reset */
|
||||
&gpio_simple 29 0>; /* image_master_en */
|
||||
|
||||
ifm,csi-addr-bus-width = <24>;
|
||||
ifm,csi-data-bus-width = <8>;
|
||||
ifm,csi-wait-cycles = <0>;
|
||||
};
|
||||
|
||||
The base address of the used chip select is specified in the
|
||||
ranges property of the parent localbus node, for example:
|
||||
|
||||
ranges = <0 0 0xff000000 0x01000000
|
||||
3 0 0xe3000000 0x00100000>;
|
Loading…
Reference in a new issue