diff --git a/Documentation/driver-api/gpio/board.rst b/Documentation/driver-api/gpio/board.rst
index 4e3adf31c8d1..b33aa04f213f 100644
--- a/Documentation/driver-api/gpio/board.rst
+++ b/Documentation/driver-api/gpio/board.rst
@@ -6,7 +6,7 @@ This document explains how GPIOs can be assigned to given devices and functions.
 
 Note that it only applies to the new descriptor-based interface. For a
 description of the deprecated integer-based GPIO interface please refer to
-gpio-legacy.txt (actually, there is no real mapping possible with the old
+legacy.rst (actually, there is no real mapping possible with the old
 interface; you just fetch an integer from somewhere and request the
 corresponding GPIO).
 
diff --git a/Documentation/driver-api/gpio/consumer.rst b/Documentation/driver-api/gpio/consumer.rst
index 47869ca8ccf0..72bcf5f5e3a2 100644
--- a/Documentation/driver-api/gpio/consumer.rst
+++ b/Documentation/driver-api/gpio/consumer.rst
@@ -4,7 +4,7 @@ GPIO Descriptor Consumer Interface
 
 This document describes the consumer interface of the GPIO framework. Note that
 it describes the new descriptor-based interface. For a description of the
-deprecated integer-based GPIO interface please refer to gpio-legacy.txt.
+deprecated integer-based GPIO interface please refer to legacy.rst.
 
 
 Guidelines for GPIOs consumers
@@ -78,7 +78,7 @@ whether the line is configured active high or active low (see
 
 The two last flags are used for use cases where open drain is mandatory, such
 as I2C: if the line is not already configured as open drain in the mappings
-(see board.txt), then open drain will be enforced anyway and a warning will be
+(see board.rst), then open drain will be enforced anyway and a warning will be
 printed that the board configuration needs to be updated to match the use case.
 
 Both functions return either a valid GPIO descriptor, or an error code checkable
@@ -270,7 +270,7 @@ driven.
 The same is applicable for open drain or open source output lines: those do not
 actively drive their output high (open drain) or low (open source), they just
 switch their output to a high impedance value. The consumer should not need to
-care. (For details read about open drain in driver.txt.)
+care. (For details read about open drain in driver.rst.)
 
 With this, all the gpiod_set_(array)_value_xxx() functions interpret the
 parameter "value" as "asserted" ("1") or "de-asserted" ("0"). The physical line
diff --git a/Documentation/driver-api/gpio/intro.rst b/Documentation/driver-api/gpio/intro.rst
index 2e924fb5b3d5..c9c19243b97f 100644
--- a/Documentation/driver-api/gpio/intro.rst
+++ b/Documentation/driver-api/gpio/intro.rst
@@ -14,12 +14,12 @@ Due to the history of GPIO interfaces in the kernel, there are two different
 ways to obtain and use GPIOs:
 
   - The descriptor-based interface is the preferred way to manipulate GPIOs,
-    and is described by all the files in this directory excepted gpio-legacy.txt.
+    and is described by all the files in this directory excepted legacy.rst.
   - The legacy integer-based interface which is considered deprecated (but still
-    usable for compatibility reasons) is documented in gpio-legacy.txt.
+    usable for compatibility reasons) is documented in legacy.rst.
 
 The remainder of this document applies to the new descriptor-based interface.
-gpio-legacy.txt contains the same information applied to the legacy
+legacy.rst contains the same information applied to the legacy
 integer-based interface.
 
 
diff --git a/MAINTAINERS b/MAINTAINERS
index 398b89e01a44..cb5aaeb84ac4 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -8498,6 +8498,7 @@ F:	Documentation/devicetree/bindings/gpio/
 F:	Documentation/driver-api/gpio/
 F:	drivers/gpio/
 F:	include/asm-generic/gpio.h
+F:	include/dt-bindings/gpio/
 F:	include/linux/gpio.h
 F:	include/linux/gpio/
 F:	include/linux/of_gpio.h
diff --git a/drivers/gpio/gpio-grgpio.c b/drivers/gpio/gpio-grgpio.c
index df563616f943..bea0e32c195d 100644
--- a/drivers/gpio/gpio-grgpio.c
+++ b/drivers/gpio/gpio-grgpio.c
@@ -434,25 +434,13 @@ static int grgpio_probe(struct platform_device *ofdev)
 static int grgpio_remove(struct platform_device *ofdev)
 {
 	struct grgpio_priv *priv = platform_get_drvdata(ofdev);
-	int i;
-	int ret = 0;
-
-	if (priv->domain) {
-		for (i = 0; i < GRGPIO_MAX_NGPIO; i++) {
-			if (priv->uirqs[i].refcnt != 0) {
-				ret = -EBUSY;
-				goto out;
-			}
-		}
-	}
 
 	gpiochip_remove(&priv->gc);
 
 	if (priv->domain)
 		irq_domain_remove(priv->domain);
 
-out:
-	return ret;
+	return 0;
 }
 
 static const struct of_device_id grgpio_match[] = {
diff --git a/drivers/gpio/gpio-mxs.c b/drivers/gpio/gpio-mxs.c
index c5166cd47c9c..7f59e5d936c2 100644
--- a/drivers/gpio/gpio-mxs.c
+++ b/drivers/gpio/gpio-mxs.c
@@ -1,6 +1,6 @@
 // SPDX-License-Identifier: GPL-2.0+
 //
-// MXC GPIO support. (c) 2008 Daniel Mack <daniel@caiaq.de>
+// MXS GPIO support. (c) 2008 Daniel Mack <daniel@caiaq.de>
 // Copyright 2008 Juergen Beisert, kernel@pengutronix.de
 //
 // Based on code from Freescale,
diff --git a/drivers/gpio/gpio-realtek-otto.c b/drivers/gpio/gpio-realtek-otto.c
index c52b2cb1acae..63dcf42f7c20 100644
--- a/drivers/gpio/gpio-realtek-otto.c
+++ b/drivers/gpio/gpio-realtek-otto.c
@@ -172,6 +172,8 @@ static void realtek_gpio_irq_unmask(struct irq_data *data)
 	unsigned long flags;
 	u16 m;
 
+	gpiochip_enable_irq(&ctrl->gc, line);
+
 	raw_spin_lock_irqsave(&ctrl->lock, flags);
 	m = ctrl->intr_mask[port];
 	m |= realtek_gpio_imr_bits(port_pin, REALTEK_GPIO_IMR_LINE_MASK);
@@ -195,6 +197,8 @@ static void realtek_gpio_irq_mask(struct irq_data *data)
 	ctrl->intr_mask[port] = m;
 	realtek_gpio_write_imr(ctrl, port, ctrl->intr_type[port], m);
 	raw_spin_unlock_irqrestore(&ctrl->lock, flags);
+
+	gpiochip_disable_irq(&ctrl->gc, line);
 }
 
 static int realtek_gpio_irq_set_type(struct irq_data *data, unsigned int flow_type)
@@ -315,13 +319,15 @@ static int realtek_gpio_irq_init(struct gpio_chip *gc)
 	return 0;
 }
 
-static struct irq_chip realtek_gpio_irq_chip = {
+static const struct irq_chip realtek_gpio_irq_chip = {
 	.name = "realtek-otto-gpio",
 	.irq_ack = realtek_gpio_irq_ack,
 	.irq_mask = realtek_gpio_irq_mask,
 	.irq_unmask = realtek_gpio_irq_unmask,
 	.irq_set_type = realtek_gpio_irq_set_type,
 	.irq_set_affinity = realtek_gpio_irq_set_affinity,
+	.flags = IRQCHIP_IMMUTABLE,
+	GPIOCHIP_IRQ_RESOURCE_HELPERS,
 };
 
 static const struct of_device_id realtek_gpio_of_match[] = {
@@ -404,7 +410,7 @@ static int realtek_gpio_probe(struct platform_device *pdev)
 	irq = platform_get_irq_optional(pdev, 0);
 	if (!(dev_flags & GPIO_INTERRUPTS_DISABLED) && irq > 0) {
 		girq = &ctrl->gc.irq;
-		girq->chip = &realtek_gpio_irq_chip;
+		gpio_irq_chip_set_chip(girq, &realtek_gpio_irq_chip);
 		girq->default_type = IRQ_TYPE_NONE;
 		girq->handler = handle_bad_irq;
 		girq->parent_handler = realtek_gpio_irq_handler;
diff --git a/drivers/gpio/gpio-winbond.c b/drivers/gpio/gpio-winbond.c
index 7f8f5b02e31d..4b61d975cc0e 100644
--- a/drivers/gpio/gpio-winbond.c
+++ b/drivers/gpio/gpio-winbond.c
@@ -385,12 +385,13 @@ static int winbond_gpio_get(struct gpio_chip *gc, unsigned int offset)
 	unsigned long *base = gpiochip_get_data(gc);
 	const struct winbond_gpio_info *info;
 	bool val;
+	int ret;
 
 	winbond_gpio_get_info(&offset, &info);
 
-	val = winbond_sio_enter(*base);
-	if (val)
-		return val;
+	ret = winbond_sio_enter(*base);
+	if (ret)
+		return ret;
 
 	winbond_sio_select_logical(*base, info->dev);
 
diff --git a/include/linux/gpio/driver.h b/include/linux/gpio/driver.h
index b1e0f1f8ee2e..54c3c6506503 100644
--- a/include/linux/gpio/driver.h
+++ b/include/linux/gpio/driver.h
@@ -167,21 +167,24 @@ struct gpio_irq_chip {
 	 */
 	irq_flow_handler_t parent_handler;
 
-	/**
-	 * @parent_handler_data:
-	 *
-	 * If @per_parent_data is false, @parent_handler_data is a single
-	 * pointer used as the data associated with every parent interrupt.
-	 *
-	 * @parent_handler_data_array:
-	 *
-	 * If @per_parent_data is true, @parent_handler_data_array is
-	 * an array of @num_parents pointers, and is used to associate
-	 * different data for each parent. This cannot be NULL if
-	 * @per_parent_data is true.
-	 */
 	union {
+		/**
+		 * @parent_handler_data:
+		 *
+		 * If @per_parent_data is false, @parent_handler_data is a
+		 * single pointer used as the data associated with every
+		 * parent interrupt.
+		 */
 		void *parent_handler_data;
+
+		/**
+		 * @parent_handler_data_array:
+		 *
+		 * If @per_parent_data is true, @parent_handler_data_array is
+		 * an array of @num_parents pointers, and is used to associate
+		 * different data for each parent. This cannot be NULL if
+		 * @per_parent_data is true.
+		 */
 		void **parent_handler_data_array;
 	};