diff --git a/drivers/net/usb/r8152.c b/drivers/net/usb/r8152.c index 65232848b31d..afb20c0ed688 100644 --- a/drivers/net/usb/r8152.c +++ b/drivers/net/usb/r8152.c @@ -773,6 +773,9 @@ enum rtl8152_flags { SCHEDULE_TASKLET, GREEN_ETHERNET, RX_EPROTO, + IN_PRE_RESET, + PROBED_WITH_NO_ERRORS, + PROBE_SHOULD_RETRY, }; #define DEVICE_ID_LENOVO_USB_C_TRAVEL_HUB 0x721e @@ -953,6 +956,8 @@ struct r8152 { u8 version; u8 duplex; u8 autoneg; + + unsigned int reg_access_reset_count; }; /** @@ -1200,6 +1205,96 @@ static unsigned int agg_buf_sz = 16384; #define RTL_LIMITED_TSO_SIZE (size_to_mtu(agg_buf_sz) - sizeof(struct tx_desc)) +/* If register access fails then we block access and issue a reset. If this + * happens too many times in a row without a successful access then we stop + * trying to reset and just leave access blocked. + */ +#define REGISTER_ACCESS_MAX_RESETS 3 + +static void rtl_set_inaccessible(struct r8152 *tp) +{ + set_bit(RTL8152_INACCESSIBLE, &tp->flags); + smp_mb__after_atomic(); +} + +static void rtl_set_accessible(struct r8152 *tp) +{ + clear_bit(RTL8152_INACCESSIBLE, &tp->flags); + smp_mb__after_atomic(); +} + +static +int r8152_control_msg(struct r8152 *tp, unsigned int pipe, __u8 request, + __u8 requesttype, __u16 value, __u16 index, void *data, + __u16 size, const char *msg_tag) +{ + struct usb_device *udev = tp->udev; + int ret; + + if (test_bit(RTL8152_INACCESSIBLE, &tp->flags)) + return -ENODEV; + + ret = usb_control_msg(udev, pipe, request, requesttype, + value, index, data, size, + USB_CTRL_GET_TIMEOUT); + + /* No need to issue a reset to report an error if the USB device got + * unplugged; just return immediately. + */ + if (ret == -ENODEV) + return ret; + + /* If the write was successful then we're done */ + if (ret >= 0) { + tp->reg_access_reset_count = 0; + return ret; + } + + dev_err(&udev->dev, + "Failed to %s %d bytes at %#06x/%#06x (%d)\n", + msg_tag, size, value, index, ret); + + /* Block all future register access until we reset. Much of the code + * in the driver doesn't check for errors. Notably, many parts of the + * driver do a read/modify/write of a register value without + * confirming that the read succeeded. Writing back modified garbage + * like this can fully wedge the adapter, requiring a power cycle. + */ + rtl_set_inaccessible(tp); + + /* If probe hasn't yet finished, then we'll request a retry of the + * whole probe routine if we get any control transfer errors. We + * never have to clear this bit since we free/reallocate the whole "tp" + * structure if we retry probe. + */ + if (!test_bit(PROBED_WITH_NO_ERRORS, &tp->flags)) { + set_bit(PROBE_SHOULD_RETRY, &tp->flags); + return ret; + } + + /* Failing to access registers in pre-reset is not surprising since we + * wouldn't be resetting if things were behaving normally. The register + * access we do in pre-reset isn't truly mandatory--we're just reusing + * the disable() function and trying to be nice by powering the + * adapter down before resetting it. Thus, if we're in pre-reset, + * we'll return right away and not try to queue up yet another reset. + * We know the post-reset is already coming. + */ + if (test_bit(IN_PRE_RESET, &tp->flags)) + return ret; + + if (tp->reg_access_reset_count < REGISTER_ACCESS_MAX_RESETS) { + usb_queue_reset_device(tp->intf); + tp->reg_access_reset_count++; + } else if (tp->reg_access_reset_count == REGISTER_ACCESS_MAX_RESETS) { + dev_err(&udev->dev, + "Tried to reset %d times; giving up.\n", + REGISTER_ACCESS_MAX_RESETS); + } + + return ret; +} + static int get_registers(struct r8152 *tp, u16 value, u16 index, u16 size, void *data) { @@ -1210,9 +1305,10 @@ int get_registers(struct r8152 *tp, u16 value, u16 index, u16 size, void *data) if (!tmp) return -ENOMEM; - ret = usb_control_msg(tp->udev, tp->pipe_ctrl_in, - RTL8152_REQ_GET_REGS, RTL8152_REQT_READ, - value, index, tmp, size, USB_CTRL_GET_TIMEOUT); + ret = r8152_control_msg(tp, tp->pipe_ctrl_in, + RTL8152_REQ_GET_REGS, RTL8152_REQT_READ, + value, index, tmp, size, "read"); + if (ret < 0) memset(data, 0xff, size); else @@ -1233,9 +1329,9 @@ int set_registers(struct r8152 *tp, u16 value, u16 index, u16 size, void *data) if (!tmp) return -ENOMEM; - ret = usb_control_msg(tp->udev, tp->pipe_ctrl_out, - RTL8152_REQ_SET_REGS, RTL8152_REQT_WRITE, - value, index, tmp, size, USB_CTRL_SET_TIMEOUT); + ret = r8152_control_msg(tp, tp->pipe_ctrl_out, + RTL8152_REQ_SET_REGS, RTL8152_REQT_WRITE, + value, index, tmp, size, "write"); kfree(tmp); @@ -1244,10 +1340,8 @@ int set_registers(struct r8152 *tp, u16 value, u16 index, u16 size, void *data) static void rtl_set_unplug(struct r8152 *tp) { - if (tp->udev->state == USB_STATE_NOTATTACHED) { - set_bit(RTL8152_INACCESSIBLE, &tp->flags); - smp_mb__after_atomic(); - } + if (tp->udev->state == USB_STATE_NOTATTACHED) + rtl_set_inaccessible(tp); } static int generic_ocp_read(struct r8152 *tp, u16 index, u16 size, @@ -8262,7 +8356,7 @@ static int rtl8152_pre_reset(struct usb_interface *intf) struct r8152 *tp = usb_get_intfdata(intf); struct net_device *netdev; - if (!tp) + if (!tp || !test_bit(PROBED_WITH_NO_ERRORS, &tp->flags)) return 0; netdev = tp->netdev; @@ -8277,7 +8371,9 @@ static int rtl8152_pre_reset(struct usb_interface *intf) napi_disable(&tp->napi); if (netif_carrier_ok(netdev)) { mutex_lock(&tp->control); + set_bit(IN_PRE_RESET, &tp->flags); tp->rtl_ops.disable(tp); + clear_bit(IN_PRE_RESET, &tp->flags); mutex_unlock(&tp->control); } @@ -8290,9 +8386,11 @@ static int rtl8152_post_reset(struct usb_interface *intf) struct net_device *netdev; struct sockaddr sa; - if (!tp) + if (!tp || !test_bit(PROBED_WITH_NO_ERRORS, &tp->flags)) return 0; + rtl_set_accessible(tp); + /* reset the MAC address in case of policy change */ if (determine_ethernet_addr(tp, &sa) >= 0) { rtnl_lock(); @@ -9494,17 +9592,29 @@ static u8 __rtl_get_hw_ver(struct usb_device *udev) __le32 *tmp; u8 version; int ret; + int i; tmp = kmalloc(sizeof(*tmp), GFP_KERNEL); if (!tmp) return 0; - ret = usb_control_msg(udev, usb_rcvctrlpipe(udev, 0), - RTL8152_REQ_GET_REGS, RTL8152_REQT_READ, - PLA_TCR0, MCU_TYPE_PLA, tmp, sizeof(*tmp), - USB_CTRL_GET_TIMEOUT); - if (ret > 0) - ocp_data = (__le32_to_cpu(*tmp) >> 16) & VERSION_MASK; + /* Retry up to 3 times in case there is a transitory error. We do this + * since retrying a read of the version is always safe and this + * function doesn't take advantage of r8152_control_msg(). + */ + for (i = 0; i < 3; i++) { + ret = usb_control_msg(udev, usb_rcvctrlpipe(udev, 0), + RTL8152_REQ_GET_REGS, RTL8152_REQT_READ, + PLA_TCR0, MCU_TYPE_PLA, tmp, sizeof(*tmp), + USB_CTRL_GET_TIMEOUT); + if (ret > 0) { + ocp_data = (__le32_to_cpu(*tmp) >> 16) & VERSION_MASK; + break; + } + } + + if (i != 0 && ret > 0) + dev_warn(&udev->dev, "Needed %d retries to read version\n", i); kfree(tmp); @@ -9603,25 +9713,14 @@ static bool rtl8152_supports_lenovo_macpassthru(struct usb_device *udev) return 0; } -static int rtl8152_probe(struct usb_interface *intf, - const struct usb_device_id *id) +static int rtl8152_probe_once(struct usb_interface *intf, + const struct usb_device_id *id, u8 version) { struct usb_device *udev = interface_to_usbdev(intf); struct r8152 *tp; struct net_device *netdev; - u8 version; int ret; - if (intf->cur_altsetting->desc.bInterfaceClass != USB_CLASS_VENDOR_SPEC) - return -ENODEV; - - if (!rtl_check_vendor_ok(intf)) - return -ENODEV; - - version = rtl8152_get_version(intf); - if (version == RTL_VER_UNKNOWN) - return -ENODEV; - usb_reset_device(udev); netdev = alloc_etherdev(sizeof(struct r8152)); if (!netdev) { @@ -9784,10 +9883,20 @@ static int rtl8152_probe(struct usb_interface *intf, else device_set_wakeup_enable(&udev->dev, false); + /* If we saw a control transfer error while probing then we may + * want to try probe() again. Consider this an error. + */ + if (test_bit(PROBE_SHOULD_RETRY, &tp->flags)) + goto out2; + + set_bit(PROBED_WITH_NO_ERRORS, &tp->flags); netif_info(tp, probe, netdev, "%s\n", DRIVER_VERSION); return 0; +out2: + unregister_netdev(netdev); + out1: tasklet_kill(&tp->tx_tl); cancel_delayed_work_sync(&tp->hw_phy_work); @@ -9796,10 +9905,46 @@ static int rtl8152_probe(struct usb_interface *intf, rtl8152_release_firmware(tp); usb_set_intfdata(intf, NULL); out: + if (test_bit(PROBE_SHOULD_RETRY, &tp->flags)) + ret = -EAGAIN; + free_netdev(netdev); return ret; } +#define RTL8152_PROBE_TRIES 3 + +static int rtl8152_probe(struct usb_interface *intf, + const struct usb_device_id *id) +{ + u8 version; + int ret; + int i; + + if (intf->cur_altsetting->desc.bInterfaceClass != USB_CLASS_VENDOR_SPEC) + return -ENODEV; + + if (!rtl_check_vendor_ok(intf)) + return -ENODEV; + + version = rtl8152_get_version(intf); + if (version == RTL_VER_UNKNOWN) + return -ENODEV; + + for (i = 0; i < RTL8152_PROBE_TRIES; i++) { + ret = rtl8152_probe_once(intf, id, version); + if (ret != -EAGAIN) + break; + } + if (ret == -EAGAIN) { + dev_err(&intf->dev, + "r8152 failed probe after %d tries; giving up\n", i); + return -ENODEV; + } + + return ret; +} + static void rtl8152_disconnect(struct usb_interface *intf) { struct r8152 *tp = usb_get_intfdata(intf);