From ed9ff5d7e864b02fbd4913f087c9d540f0384e1d Mon Sep 17 00:00:00 2001 From: Felipe Contreras Date: Sun, 4 Jul 2010 16:36:24 +0300 Subject: [PATCH] staging: ti dspbridge: improve Kconfig Signed-off-by: Felipe Contreras Signed-off-by: Greg Kroah-Hartman --- drivers/staging/tidspbridge/Kconfig | 19 +++++++------------ 1 file changed, 7 insertions(+), 12 deletions(-) diff --git a/drivers/staging/tidspbridge/Kconfig b/drivers/staging/tidspbridge/Kconfig index 6ce443a54eea..4d63b66d8e26 100644 --- a/drivers/staging/tidspbridge/Kconfig +++ b/drivers/staging/tidspbridge/Kconfig @@ -17,7 +17,6 @@ menuconfig TIDSPBRIDGE config TIDSPBRIDGE_DVFS bool "Enable Bridge Dynamic Voltage and Frequency Scaling (DVFS)" depends on TIDSPBRIDGE && OMAP_PM_SRF && CPU_FREQ - default n help DVFS allows DSP Bridge to initiate the operating point change to scale the chip voltage and frequency in order to match the @@ -33,14 +32,15 @@ config TIDSPBRIDGE_MEMPOOL_SIZE failure under heavy memory fragmentation after some use time. config TIDSPBRIDGE_DEBUG - bool "DSP Bridge Debug Support" + bool "Debug Support" depends on TIDSPBRIDGE help Say Y to enable Bridge debugging capabilities config TIDSPBRIDGE_RECOVERY - bool "DSP Recovery Support" + bool "Recovery Support" depends on TIDSPBRIDGE + default y help In case of DSP fatal error, BRIDGE driver will try to recover itself. @@ -48,7 +48,6 @@ config TIDSPBRIDGE_RECOVERY config TIDSPBRIDGE_CACHE_LINE_CHECK bool "Check buffers to be 128 byte aligned" depends on TIDSPBRIDGE - default n help When the DSP processes data, the DSP cache controller loads 128-Byte chunks (lines) from SDRAM and writes the data back in 128-Byte chunks. @@ -60,27 +59,23 @@ config TIDSPBRIDGE_CACHE_LINE_CHECK byte alignment, buffers failing this check will be rejected. config TIDSPBRIDGE_WDT3 - bool "Enable WDT3 interruptions" + bool "Enable watchdog timer" depends on TIDSPBRIDGE - default n help WTD3 is managed by DSP and once it is enabled, DSP side bridge is in charge of refreshing the timer before overflow, if the DSP hangs MPU will caught the interrupt and try to recover DSP. config TIDSPBRIDGE_WDT_TIMEOUT - int "DSP watchdog timer timeout (in secs)" - depends on TIDSPBRIDGE_WDT3 + int "Watchdog timer timeout (in secs)" + depends on TIDSPBRIDGE && TIDSPBRIDGE_WDT3 default 5 help Watchdog timer timeout value, after that time if the watchdog timer counter is not reset the wdt overflow interrupt will be triggered -comment "Bridge Notifications" - depends on TIDSPBRIDGE - config TIDSPBRIDGE_NTFY_PWRERR - bool "Notify DSP Power Error" + bool "Notify power errors" depends on TIDSPBRIDGE help Enable notifications to registered clients on the event of power errror