This is the 1/4 patch to support device-replace on zoned filesystems.
We have two types of IOs during the device replace process. One is an IO
to "copy" (by the scrub functions) all the device extents from the source
device to the destination device. The other one is an IO to "clone" (by
handle_ops_on_dev_replace()) new incoming write IOs from users to the
source device into the target device.
Cloning incoming IOs can break the sequential write rule in on target
device. When a write is mapped in the middle of a block group, the IO is
directed to the middle of a target device zone, which breaks the
sequential write requirement.
However, the cloning function cannot be disabled since incoming IOs
targeting already copied device extents must be cloned so that the IO is
executed on the target device.
We cannot use dev_replace->cursor_{left,right} to determine whether a bio
is going to a not yet copied region. Since we have a time gap between
finishing btrfs_scrub_dev() and rewriting the mapping tree in
btrfs_dev_replace_finishing(), we can have a newly allocated device extent
which is never cloned nor copied.
So the point is to copy only already existing device extents. This patch
introduces mark_block_group_to_copy() to mark existing block groups as a
target of copying. Then, handle_ops_on_dev_replace() and dev-replace can
check the flag to do their job.
Also, btrfs_finish_block_group_to_copy() will check if the copied stripe
is the last stripe in the block group. With the last stripe copied,
the to_copy flag is finally disabled. Afterwards we can safely clone
incoming IOs on this block group.
Reviewed-by: Josef Bacik <josef@toxicpanda.com>
Signed-off-by: Naohiro Aota <naohiro.aota@wdc.com>
Signed-off-by: David Sterba <dsterba@suse.com>
The attribute is more relaxed than const and the functions could
dereference pointers, as long as the observable state is not changed. We
do have such functions, based on -Wsuggest-attribute=pure .
The visible effects of this patch are negligible, there are differences
in the assembly but hard to summarize.
Reviewed-by: Nikolay Borisov <nborisov@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
The dev-replace locking functions are now trivial wrappers around rw
semaphore that can be used directly everywhere. No functional change.
Signed-off-by: David Sterba <dsterba@suse.com>
After the rw semaphore has been added, the custom blocking using
::blocking_readers and ::read_lock_wq is redundant.
The blocking logic in __btrfs_map_block is replaced by extending the
time the semaphore is held, that has the same blocking effect on writes
as the previous custom scheme that waited until ::blocking_readers was
zero.
Signed-off-by: David Sterba <dsterba@suse.com>
There isn't any other consumer other than in its own file dev-replace.c.
Signed-off-by: Anand Jain <anand.jain@oracle.com>
Reviewed-by: Nikolay Borisov <nborisov@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
Too trivial, the purpose can be simply documented in a comment.
Reviewed-by: Omar Sandoval <osandov@fb.com>
Reviewed-by: Anand Jain <anand.jain@oracle.com>
Signed-off-by: David Sterba <dsterba@suse.com>
The wrapper is too trivial, open coding does not make it less readable.
Reviewed-by: Omar Sandoval <osandov@fb.com>
Reviewed-by: Anand Jain <anand.jain@oracle.com>
Signed-off-by: David Sterba <dsterba@suse.com>
There's a single caller and the function name does not say it's actually
taking the lock, so open coding makes it more explicit.
For now, btrfs_dev_replace_read_lock is used instead of read_lock so
it's paired with the unlocking wrapper in the same block.
Reviewed-by: Anand Jain <anand.jain@oracle.com>
Signed-off-by: David Sterba <dsterba@suse.com>
Remove GPL boilerplate text (long, short, one-line) and keep the rest,
ie. personal, company or original source copyright statements. Add the
SPDX header.
Unify the include protection macros to match the file names.
Signed-off-by: David Sterba <dsterba@suse.com>
The current calls are unclear in what way btrfs_dev_replace_lock takes
the locks, so drop the argument, split the helpers and use similar
naming as for read and write locks.
Signed-off-by: David Sterba <dsterba@suse.com>
Current u64 return from btrfs_dev_replace_cancel() was probably done
to match the btrfs_ioctl_dev_replace_args::result. However as our
actual return value fits in int, and it further gets typecast to u64,
so just return int.
Signed-off-by: Anand Jain <anand.jain@oracle.com>
Reviewed-by: David Sterba <dsterba@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
Remove __ which is for the special functions.
Signed-off-by: Anand Jain <anand.jain@oracle.com>
Reviewed-by: David Sterba <dsterba@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
btrfs_dev_replace_cancel() calls __btrfs_dev_replace_cancel() for the
actual cancel so just open code it.
Signed-off-by: Anand Jain <anand.jain@oracle.com>
Reviewed-by: David Sterba <dsterba@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
There are loads of functions in btrfs that accept a root parameter
but only use it to obtain an fs_info pointer. Let's convert those to
just accept an fs_info pointer directly.
Signed-off-by: Jeff Mahoney <jeffm@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
A refactor patch, and avoids user input verification in the
btrfs_dev_replace_start(), and so this function can be reused.
Signed-off-by: Anand Jain <anand.jain@oracle.com>
Signed-off-by: David Sterba <dsterba@suse.com>
Xfstests btrfs/011 complains about a deadlock warning,
[ 1226.649039] =========================================================
[ 1226.649039] [ INFO: possible irq lock inversion dependency detected ]
[ 1226.649039] 4.1.0+ #270 Not tainted
[ 1226.649039] ---------------------------------------------------------
[ 1226.652955] kswapd0/46 just changed the state of lock:
[ 1226.652955] (&delayed_node->mutex){+.+.-.}, at: [<ffffffff81458735>] __btrfs_release_delayed_node+0x45/0x1d0
[ 1226.652955] but this lock took another, RECLAIM_FS-unsafe lock in the past:
[ 1226.652955] (&fs_info->dev_replace.lock){+.+.+.}
and interrupts could create inverse lock ordering between them.
[ 1226.652955]
other info that might help us debug this:
[ 1226.652955] Chain exists of:
&delayed_node->mutex --> &found->groups_sem --> &fs_info->dev_replace.lock
[ 1226.652955] Possible interrupt unsafe locking scenario:
[ 1226.652955] CPU0 CPU1
[ 1226.652955] ---- ----
[ 1226.652955] lock(&fs_info->dev_replace.lock);
[ 1226.652955] local_irq_disable();
[ 1226.652955] lock(&delayed_node->mutex);
[ 1226.652955] lock(&found->groups_sem);
[ 1226.652955] <Interrupt>
[ 1226.652955] lock(&delayed_node->mutex);
[ 1226.652955]
*** DEADLOCK ***
Commit 084b6e7c76 ("btrfs: Fix a lockdep warning when running xfstest.") tried
to fix a similar one that has the exactly same warning, but with that, we still
run to this.
The above lock chain comes from
btrfs_commit_transaction
->btrfs_run_delayed_items
...
->__btrfs_update_delayed_inode
...
->__btrfs_cow_block
...
->find_free_extent
->cache_block_group
->load_free_space_cache
->btrfs_readpages
->submit_one_bio
...
->__btrfs_map_block
->btrfs_dev_replace_lock
However, with high memory pressure, tasks which hold dev_replace.lock can
be interrupted by kswapd and then kswapd is intended to release memory occupied
by superblock, inodes and dentries, where we may call evict_inode, and it comes
to
[ 1226.652955] [<ffffffff81458735>] __btrfs_release_delayed_node+0x45/0x1d0
[ 1226.652955] [<ffffffff81459e74>] btrfs_remove_delayed_node+0x24/0x30
[ 1226.652955] [<ffffffff8140c5fe>] btrfs_evict_inode+0x34e/0x700
delayed_node->mutex may be acquired in __btrfs_release_delayed_node(), and it leads
to a ABBA deadlock.
To fix this, we can use "blocking rwlock" used in the case of extent_buffer, but
things are simpler here since we only needs read's spinlock to blocking lock.
With this, btrfs/011 no more produces warnings in dmesg.
Signed-off-by: Liu Bo <bo.li.liu@oracle.com>
Signed-off-by: David Sterba <dsterba@suse.com>
This adds a new file to the sources together with the header file
and the changes to ioctl.h and ctree.h that are required by the
new C source file. Additionally, 4 new functions are added to
volume.c that deal with device creation and destruction.
Signed-off-by: Stefan Behrens <sbehrens@giantdisaster.de>
Signed-off-by: Chris Mason <chris.mason@fusionio.com>
The device replace procedure makes use of the scrub code. The scrub
code is the most efficient code to read the allocated data of a disk,
i.e. it reads sequentially in order to avoid disk head movements, it
skips unallocated blocks, it uses read ahead mechanisms, and it
contains all the code to detect and repair defects.
This commit adds code to scrub to allow the scrub code to copy read
data to another disk.
One goal is to be able to perform as fast as possible. Therefore the
write requests are collected until huge bios are built, and the
write process is decoupled from the read process with some kind of
flow control, of course, in order to limit the allocated memory.
The best performance on spinning disks could by reached when the
head movements are avoided as much as possible. Therefore a single
worker is used to interface the read process with the write process.
The regular scrub operation works as fast as before, it is not
negatively influenced and actually it is more or less unchanged.
Signed-off-by: Stefan Behrens <sbehrens@giantdisaster.de>
Signed-off-by: Chris Mason <chris.mason@fusionio.com>
