We haven't finalized send stream v3 yet, so gate the send stream version
behind CONFIG_BTRFS_DEBUG as we want some way to test it.
The original verity send did not check the protocol version, so add that
actual protection as well.
Reviewed-by: Anand Jain <anand.jain@oracle.com>
Signed-off-by: Boris Burkov <boris@bur.io>
Signed-off-by: David Sterba <dsterba@suse.com>
Preserve the fs-verity status of a btrfs file across send/recv.
There is no facility for installing the Merkle tree contents directly on
the receiving filesystem, so we package up the parameters used to enable
verity found in the verity descriptor. This gives the receive side
enough information to properly enable verity again. Note that this means
that receive will have to re-compute the whole Merkle tree, similar to
how compression worked before encoded_write.
Since the file becomes read-only after verity is enabled, it is
important that verity is added to the send stream after any file writes.
Therefore, when we process a verity item, merely note that it happened,
then actually create the command in the send stream during
'finish_inode_if_needed'.
This also creates V3 of the send stream format, without any format
changes besides adding the new commands and attributes.
Signed-off-by: Boris Burkov <boris@bur.io>
Signed-off-by: David Sterba <dsterba@suse.com>
There are file attributes inherited from previous ext2 SETFLAGS/GETFLAGS
and later from XFLAGS interfaces, now commonly found under the
'fileattr' API. This corresponds to the individual inode bits and that's
part of the on-disk format, so this is suitable for the protocol. The
other interfaces contain a lot of cruft or bits that btrfs does not
support yet.
Currently the value is u64 and matches btrfs_inode_item. Not all the
bits can be set by ioctls (like NODATASUM or READONLY), but we can send
them over the protocol and leave it up to the receiving side what and
how to apply.
As some of the flags, eg. IMMUTABLE, can prevent any further changes,
the receiving side needs to understand that and apply the changes in the
right order, or possibly with some intermediate steps. This should be
easier, future proof and simpler on the protocol layer than implementing
in kernel.
Reviewed-by: Omar Sandoval <osandov@fb.com>
Signed-off-by: David Sterba <dsterba@suse.com>
We don't need this ifdef as the header file is not shared, the protocol
definition used by userspace should be from libbtrfs or libbtrfsutil.
Signed-off-by: David Sterba <dsterba@suse.com>
Now that the new support is implemented, allow the ioctl to accept v2
and the compressed flag, and update the version in sysfs.
Signed-off-by: Omar Sandoval <osandov@fb.com>
Signed-off-by: David Sterba <dsterba@suse.com>
This adds the definitions of the new commands for send stream version 2
and their respective attributes: fallocate, FS_IOC_SETFLAGS (a.k.a.
chattr), and encoded writes. It also documents two changes to the send
stream format in v2: the receiver shouldn't assume a maximum command
size, and the DATA attribute is encoded differently to allow for writes
larger than 64k. These will be implemented in subsequent changes, and
then the ioctl will accept the new version and flag.
Reviewed-by: Josef Bacik <josef@toxicpanda.com>
Signed-off-by: Omar Sandoval <osandov@fb.com>
Signed-off-by: David Sterba <dsterba@suse.com>
Commit e77fbf9903 ("btrfs: send: prepare for v2 protocol") added
_BTRFS_SEND_C_MAX_V* macros equal to the maximum command number for the
version plus 1, but as written this creates gaps in the number space.
The maximum command number is currently 22, and __BTRFS_SEND_C_MAX_V1 is
accordingly 23. But then __BTRFS_SEND_C_MAX_V2 is 24, suggesting that v2
has a command numbered 23, and __BTRFS_SEND_C_MAX is 25, suggesting that
23 and 24 are valid commands.
Instead, let's explicitly number all of the commands, attributes, and
sentinel MAX constants.
Signed-off-by: Omar Sandoval <osandov@fb.com>
Reviewed-by: David Sterba <dsterba@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
btrfs_ioctl extracts inode from file so we can pass that into the
callbacks.
Signed-off-by: Sahil Kang <sahil.kang@asilaycomputing.com>
Reviewed-by: David Sterba <dsterba@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
This is preparatory work for send protocol update to version 2 and
higher.
We have many pending protocol update requests but still don't have the
basic protocol rev in place, the first thing that must happen is to do
the actual versioning support.
The protocol version is u32 and is a new member in the send ioctl
struct. Validity of the version field is backed by a new flag bit. Old
kernels would fail when a higher version is requested. Version protocol
0 will pick the highest supported version, BTRFS_SEND_STREAM_VERSION,
that's also exported in sysfs.
The version is still unchanged and will be increased once we have new
incompatible commands or stream updates.
Reviewed-by: Nikolay Borisov <nborisov@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
send_write() currently copies from the page cache to sctx->read_buf, and
then from sctx->read_buf to sctx->send_buf. Similarly, send_hole()
zeroes sctx->read_buf and then copies from sctx->read_buf to
sctx->send_buf. However, if we write the TLV header manually, we can
copy to sctx->send_buf directly and get rid of sctx->read_buf.
Reviewed-by: Filipe Manana <fdmanana@suse.com>
Reviewed-by: Josef Bacik <josef@toxicpanda.com>
Signed-off-by: Omar Sandoval <osandov@fb.com>
Signed-off-by: David Sterba <dsterba@suse.com>
Remove GPL boilerplate text (long, short, one-line) and keep the rest,
ie. personal, company or original source copyright statements. Add the
SPDX header.
Unify the include protection macros to match the file names.
Signed-off-by: David Sterba <dsterba@suse.com>
We pass in a pointer in our send arg struct, this means the struct size
doesn't match with 32bit user space and 64bit kernel space. Fix this by
adding a compat mode and doing the appropriate conversion.
Signed-off-by: Josef Bacik <jbacik@fb.com>
Reviewed-by: David Sterba <dsterba@suse.com>
[ move structure to the beginning, next to receive 32bit compat ]
Signed-off-by: David Sterba <dsterba@suse.com>
We use many constants to represent size and offset value. And to make
code readable we use '256 * 1024 * 1024' instead of '268435456' to
represent '256MB'. However we can make far more readable with 'SZ_256MB'
which is defined in the 'linux/sizes.h'.
So this patch replaces 'xxx * 1024 * 1024' kind of expression with
single 'SZ_xxxMB' if 'xxx' is a power of 2 then 'xxx * SZ_1M' if 'xxx' is
not a power of 2. And I haven't touched to '4096' & '8192' because it's
more intuitive than 'SZ_4KB' & 'SZ_8KB'.
Signed-off-by: Byongho Lee <bhlee.kernel@gmail.com>
Signed-off-by: David Sterba <dsterba@suse.com>
Big patch, but all it does is add statics to functions which
are in fact static, then remove the associated dead-code fallout.
removed functions:
btrfs_iref_to_path()
__btrfs_lookup_delayed_deletion_item()
__btrfs_search_delayed_insertion_item()
__btrfs_search_delayed_deletion_item()
find_eb_for_page()
btrfs_find_block_group()
range_straddles_pages()
extent_range_uptodate()
btrfs_file_extent_length()
btrfs_scrub_cancel_devid()
btrfs_start_transaction_lflush()
btrfs_print_tree() is left because it is used for debugging.
btrfs_start_transaction_lflush() and btrfs_reada_detach() are
left for symmetry.
ulist.c functions are left, another patch will take care of those.
Signed-off-by: Eric Sandeen <sandeen@redhat.com>
Signed-off-by: Josef Bacik <jbacik@fusionio.com>
This patch adds the flag, BTRFS_SEND_FLAG_NO_FILE_DATA to the btrfs send
ioctl code. When this flag is set, the btrfs send code will never write file
data into the stream (thus also avoiding expensive reads of that data in the
first place). BTRFS_SEND_C_UPDATE_EXTENT commands will be sent (instead of
BTRFS_SEND_C_WRITE) with an offset, length pair indicating the extent in
question.
This patch does not affect the operation of BTRFS_SEND_C_CLONE commands -
they will continue to be sent when a search finds an appropriate extent to
clone from.
Signed-off-by: Mark Fasheh <mfasheh@suse.de>
Signed-off-by: Josef Bacik <jbacik@fusionio.com>
This patch introduces the BTRFS_IOC_SEND ioctl that is
required for send. It allows btrfs-progs to implement
full and incremental sends. Patches for btrfs-progs will
follow.
Signed-off-by: Alexander Block <ablock84@googlemail.com>
Reviewed-by: David Sterba <dave@jikos.cz>
Reviewed-by: Arne Jansen <sensille@gmx.net>
Reviewed-by: Jan Schmidt <list.btrfs@jan-o-sch.net>
Reviewed-by: Alex Lyakas <alex.bolshoy.btrfs@gmail.com>
Boris Burkov