Commit Graph

2 Commits

Author SHA1 Message Date
Steven Rostedt (VMware) 8d6e90983a tracing: Create a sparse bitmask for pid filtering
When the trace_pid_list was created, the default pid max was 32768.
Creating a bitmask that can hold one bit for all 32768 took up 4096 (one
page). Having a one page bitmask was not much of a problem, and that was
used for mapping pids. But today, systems are bigger and can run more
tasks, and now the default pid_max is usually set to 4194304. Which means
to handle that many pids requires 524288 bytes. Worse yet, the pid_max can
be set to 2^30 (1073741824 or 1G) which would take 134217728 (128M) of
memory to store this array.

Since the pid_list array is very sparsely populated, it is a huge waste of
memory to store all possible bits for each pid when most will not be set.

Instead, use a page table scheme to store the array, and allow this to
handle up to 30 bit pids.

The pid_mask will start out with 256 entries for the first 8 MSB bits.
This will cost 1K for 32 bit architectures and 2K for 64 bit. Each of
these will have a 256 array to store the next 8 bits of the pid (another
1 or 2K). These will hold an 2K byte bitmask (which will cover the LSB
14 bits or 16384 pids).

When the trace_pid_list is allocated, it will have the 1/2K upper bits
allocated, and then it will allocate a cache for the next upper chunks and
the lower chunks (default 6 of each). Then when a bit is "set", these
chunks will be pulled from the free list and added to the array. If the
free list gets down to a lever (default 2), it will trigger an irqwork
that will refill the cache back up.

On clearing a bit, if the clear causes the bitmask to be zero, that chunk
will then be placed back into the free cache for later use, keeping the
need to allocate more down to a minimum.

Signed-off-by: Steven Rostedt (VMware) <rostedt@goodmis.org>
2021-10-05 17:38:45 -04:00
Steven Rostedt (VMware) 6954e41526 tracing: Place trace_pid_list logic into abstract functions
Instead of having the logic that does trace_pid_list open coded, wrap it in
abstract functions. This will allow a rewrite of the logic that implements
the trace_pid_list without affecting the users.

Note, this causes a change in behavior. Every time a pid is written into
the set_*_pid file, it creates a new list and uses RCU to update it. If
pid_max is lowered, but there was a pid currently in the list that was
higher than pid_max, those pids will now be removed on updating the list.
The old behavior kept that from happening.

The rewrite of the pid_list logic will no longer depend on pid_max,
and will return the old behavior.

Signed-off-by: Steven Rostedt (VMware) <rostedt@goodmis.org>
2021-10-05 17:30:08 -04:00