The dm644x and dm3xx SoCs have been removed, as have the
da850_evm/da830_evm machines, the remaining machines all use the
DT based probing and do not use the vcif driver.
Acked-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Kconfig generates include/generated/autoconf.h to make CONFIG options
available to the pre-processor. Symbols with the value 'm' are suffixed
with '_MODULE'
Here is a conflict; CONFIG_FOO=m results in '#define CONFIG_FOO_MODULE 1',
but CONFIG_FOO_MODULE=y also results in the same define.
Also, CONFIG options that end with '_MODULE' confuse the Kconfig/fixdep
interaction; fixdep always assumes CONFIG_FOO_MODULE comes from
CONFIG_FOO=m, so the dependency is not properly tracked for symbols
that end with '_MODULE'.
For these reasons, CONFIG options that end with '_MODULE' should be
avoided in general. (I am planning on adding a check in Kconfig.)
This is the only case in the current kernel.
The new option name was suggested by Péter Ujfalusi. [1]
[1] https://lore.kernel.org/all/d9e777dc-d274-92ee-4d77-711bfd553611@gmail.com/
Fixes: 147162f575 ("ASoC: ti: fix SND_SOC_DM365_VOICE_CODEC dependencies")
Signed-off-by: Masahiro Yamada <masahiroy@kernel.org>
Acked-by: Peter Ujfalusi <peter.ujfalusi@gmail.com>
Link: https://lore.kernel.org/r/20210901164009.1546967-1-masahiroy@kernel.org
Signed-off-by: Mark Brown <broonie@kernel.org>
There is a single McASP on OMAP4 (and OMAP5) which is configured to only
support DIT playback mode on a single serializer.
Add 0x200 offset to DAT port address as the TRM suggests it.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Link: https://lore.kernel.org/r/20210705194249.2385-4-peter.ujfalusi@gmail.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The TI/OMAP sound drivers use Common Clock Framework thus they cannot be
built on platforms without it (e.g. compile test on MIPS with RALINK and
SOC_RT305X):
/usr/bin/mips-linux-gnu-ld: sound/soc/ti/davinci-mcasp.o:davinci-mcasp.c:(.text+0x1c64): more undefined references to `clk_set_parent' follow
/usr/bin/mips-linux-gnu-ld: sound/soc/ti/omap-dmic.o: in function `omap_dmic_set_dai_sysclk':
omap-dmic.c:(.text+0xa5c): undefined reference to `clk_get_parent'
Reported-by: kernel test robot <lkp@intel.com>
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Link: https://lore.kernel.org/r/20201116175133.402553-4-krzk@kernel.org
Signed-off-by: Mark Brown <broonie@kernel.org>
The initial machine driver supports only j721e-cpb and the ivi addon, but
other EVMs for different K3 SoC can have similar audio setup which can
be supported by the driver with small or no modification.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Link: https://lore.kernel.org/r/20200908113204.12012-1-peter.ujfalusi@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>
SND_SOC_J721E_EVM should not select SND_SOC_PCM3168A_I2C when I2C
is not enabled. That causes build errors, so make this driver's
symbol depend on I2C.
WARNING: unmet direct dependencies detected for SND_SOC_PCM3168A_I2C
Depends on [n]: SOUND [=m] && !UML && SND [=m] && SND_SOC [=m] && I2C [=n]
Selected by [m]:
- SND_SOC_J721E_EVM [=m] && SOUND [=m] && !UML && SND [=m] && SND_SOC [=m] && (DMA_OMAP [=y] || TI_EDMA [=m] || TI_K3_UDMA [=n] || COMPILE_TEST [=y]) && (ARCH_K3_J721E_SOC [=n] || COMPILE_TEST [=y])
../sound/soc/codecs/pcm3168a-i2c.c:59:1: warning: data definition has no type or storage class
module_i2c_driver(pcm3168a_i2c_driver);
^~~~~~~~~~~~~~~~~
../sound/soc/codecs/pcm3168a-i2c.c:59:1: error: type defaults to ‘int’ in declaration of ‘module_i2c_driver’ [-Werror=implicit-int]
../sound/soc/codecs/pcm3168a-i2c.c:59:1: warning: parameter names (without types) in function declaration
../sound/soc/codecs/pcm3168a-i2c.c:49:26: warning: ‘pcm3168a_i2c_driver’ defined but not used [-Wunused-variable]
static struct i2c_driver pcm3168a_i2c_driver = {
^~~~~~~~~~~~~~~~~~~
cc1: some warnings being treated as errors
Fixes: 6748d05590 ("ASoC: ti: Add custom machine driver for j721e EVM (CPB and IVI)")
Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Acked-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Cc: Peter Ujfalusi <peter.ujfalusi@ti.com>
Cc: Mark Brown <broonie@kernel.org>
Link: https://lore.kernel.org/r/e74c690c-c7f8-fd42-e461-4f33571df4ef@infradead.org
Signed-off-by: Mark Brown <broonie@kernel.org>
The audio support on the board is using pcm3168a codec connected to McASP10
serializers in parallel setup.
The pcm3168a SCKI clock is coming via the j721e AUDIO_REFCLK2 pin.
In order to support 48KHz and 44.1KHz family of sampling rates the parent clock
for AUDIO_REFCLK2 needs to be changed between PLL4 (for 48KHz) and PLL15 (for
44.1KHz). The same PLLs are used for McASP10's AUXCLK clock via different
HSDIVIDER.
Generic card can not be used for the board as we need to switch between
clock paths for different sampling rate families and also need to change
the slot_width between 16 and 24 bit audio.
The audio support on the Infotainment Expansion Board consists of McASP0
connected to two pcm3168a codecs with dedicated set of serializers to each.
The SCKI for pcm3168a is sourced from j721e AUDIO_REFCLK0 pin.
It is extending the audio support on the CPB.
Due to the fact that the same PLL4/15 is used by both domains (CPB/IVI)
there are cross restriction on sampling rates.
The IVI side is represented as multicodec setup.
PCMs available on a plain CPB (no IVI addon):
hw:0,0 - cpb playback (8 channels)
hw:0,1 - cpb capture (6 channels)
When the IVI addon is present, additional two PCMs will be present:
hw:0,2 - ivi multicodec playback (16 channels)
hw:0,3 - ivi multicodec capture (12 channels)
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Link: https://lore.kernel.org/r/20200630125843.11561-4-peter.ujfalusi@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>
SND_SOC_DM365_VOICE_CODEC is a 'bool' option in a choice statement,
meaning it cannot be set to =m, but it selects two other drivers
that we may want to be loadable modules after all:
WARNING: unmet direct dependencies detected for SND_SOC_CQ0093VC
Depends on [m]: SOUND [=m] && !UML && SND [=m] && SND_SOC [=m]
Selected by [y]:
- SND_SOC_DM365_VOICE_CODEC [=y] && <choice>
Selected by [m]:
- SND_SOC_ALL_CODECS [=m] && SOUND [=m] && !UML && SND [=m] && SND_SOC [=m] && COMPILE_TEST [=y]
Add an intermediate symbol that sets SND_SOC_CQ0093VC and
MFD_DAVINCI_VOICECODEC to =m if SND_SOC=m.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Link: https://lore.kernel.org/r/20190920075046.3210393-1-arnd@arndb.de
Signed-off-by: Mark Brown <broonie@kernel.org>
Add SPDX license identifiers to all Make/Kconfig files which:
- Have no license information of any form
These files fall under the project license, GPL v2 only. The resulting SPDX
license identifier is:
GPL-2.0-only
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
The SND_SOC_DAVINCI_MCASP driver can use either edma or sdma as
a back-end, and it takes the presence of the respective dma engine
drivers in the configuration as an indication to which ones should be
built. However, this is flawed in multiple ways:
- With CONFIG_TI_EDMA=m and CONFIG_SND_SOC_DAVINCI_MCASP=y,
is enabled as =m, and we get a link error:
sound/soc/ti/davinci-mcasp.o: In function `davinci_mcasp_probe':
davinci-mcasp.c:(.text+0x930): undefined reference to `edma_pcm_platform_register'
- When CONFIG_SND_SOC_DAVINCI_MCASP=m has already been selected by
another driver, the same link error appears even if CONFIG_TI_EDMA
is disabled
There are possibly other issues here, but it seems that the only reasonable
solution is to always build both SND_SOC_TI_EDMA_PCM and
SND_SOC_TI_SDMA_PCM as a dependency here. Both are fairly small and
do not have any other compile-time dependencies, so the cost is
very small, and makes the configuration stage much more consistent.
Fixes: f2055e145f ("ASoC: ti: Merge davinci and omap directories")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
We no longer have these options used anywhere.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Create new directory to contain all Texas Instruments specific DAI,
platform and machine drivers instead of scattering them under davinci and
omap directories.
There is already inter dependency between the two directories becasue of
McASP (on dra7x it is serviced by sDMA, not EDMA).
With the upcoming AM654 we will need to introduce new platform driver for
UDMA and it does not fit under davinci, nor under omap.
With the move I have restructured the Kconfig to be more usable in the era
of simple-sound-card:
CPU DAIs can be selected individually and they will select the platform
driver they can be served with.
To avoid breakage, I have moved over deprecated Kconfig options so
defconfig builds will work without regression.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
For sound/soc/{omap => ti}:
Tested-by: Jarkko Nikula <jarkko.nikula@bitmer.com>
Acked-by: Jarkko Nikula <jarkko.nikula@bitmer.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Arnd Bergmann