mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2024-09-27 21:03:32 +00:00
fdf4123743
The qpl_cfg struct was used to make sure that no two different queues are using QPL with the same qpl_id. We can remove that qpl_cfg struct since now the qpl_ids map with the queues respectively as follows: For tx queues: qpl_id = tx_qid For rx queues: qpl_id = max_tx_queues + rx_qid And when XDP is used, it will need the user to reduce the tx queues to be at most half of the max_tx_queues. Then it will use the same number of tx queues starting from the end of existing tx queues for XDP. So the XDP queues will not exceed the max_tx_queues range and will not overlap with the rx queues, where the qpl_ids will not have overlapping too. Considering of that, we remove the qpl_cfg struct to get the qpl_id directly based on the queue id. Unless we are erroneously allocating a rx/tx queue that has already been allocated, we would never allocate the qpl with the same qpl_id twice. In that case, it should fail much earlier than the QPL assignment. Suggested-by: Praveen Kaligineedi <pkaligineedi@google.com> Signed-off-by: Ziwei Xiao <ziweixiao@google.com> Reviewed-by: Harshitha Ramamurthy <hramamurthy@google.com> Reviewed-by: Shailend Chand <shailend@google.com> Link: https://lore.kernel.org/r/20240417205757.778551-1-ziweixiao@google.com Signed-off-by: Jakub Kicinski <kuba@kernel.org> |
||
|---|---|---|
| .. | ||
| accel | ||
| accessibility | ||
| acpi | ||
| amba | ||
| android | ||
| ata | ||
| atm | ||
| auxdisplay | ||
| base | ||
| bcma | ||
| block | ||
| bluetooth | ||
| bus | ||
| cache | ||
| cdrom | ||
| cdx | ||
| char | ||
| clk | ||
| clocksource | ||
| comedi | ||
| connector | ||
| counter | ||
| cpufreq | ||
| cpuidle | ||
| crypto | ||
| cxl | ||
| dax | ||
| dca | ||
| devfreq | ||
| dio | ||
| dma | ||
| dma-buf | ||
| dpll | ||
| edac | ||
| eisa | ||
| extcon | ||
| firewire | ||
| firmware | ||
| fpga | ||
| fsi | ||
| gnss | ||
| gpio | ||
| gpu | ||
| greybus | ||
| hid | ||
| hsi | ||
| hte | ||
| hv | ||
| hwmon | ||
| hwspinlock | ||
| hwtracing | ||
| i2c | ||
| i3c | ||
| idle | ||
| iio | ||
| infiniband | ||
| input | ||
| interconnect | ||
| iommu | ||
| ipack | ||
| irqchip | ||
| isdn | ||
| leds | ||
| macintosh | ||
| mailbox | ||
| mcb | ||
| md | ||
| media | ||
| memory | ||
| memstick | ||
| message | ||
| mfd | ||
| misc | ||
| mmc | ||
| most | ||
| mtd | ||
| mux | ||
| net | ||
| nfc | ||
| ntb | ||
| nubus | ||
| nvdimm | ||
| nvme | ||
| nvmem | ||
| of | ||
| opp | ||
| parisc | ||
| parport | ||
| pci | ||
| pcmcia | ||
| peci | ||
| perf | ||
| phy | ||
| pinctrl | ||
| platform | ||
| pmdomain | ||
| pnp | ||
| power | ||
| powercap | ||
| pps | ||
| ps3 | ||
| ptp | ||
| pwm | ||
| rapidio | ||
| ras | ||
| regulator | ||
| remoteproc | ||
| reset | ||
| rpmsg | ||
| rtc | ||
| s390 | ||
| sbus | ||
| scsi | ||
| sh | ||
| siox | ||
| slimbus | ||
| soc | ||
| soundwire | ||
| spi | ||
| spmi | ||
| ssb | ||
| staging | ||
| target | ||
| tc | ||
| tee | ||
| thermal | ||
| thunderbolt | ||
| tty | ||
| ufs | ||
| uio | ||
| usb | ||
| vdpa | ||
| vfio | ||
| vhost | ||
| video | ||
| virt | ||
| virtio | ||
| w1 | ||
| watchdog | ||
| xen | ||
| zorro | ||
| Kconfig | ||
| Makefile | ||