mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2024-09-21 10:01:00 +00:00
f629acc6f2
According to chapter 6 of DesignWare Cores Ethernet PCS (version 3.20a) and custom design manual, add a configuration flow for switching interface mode. If the interface changes, the following setting is required: 1. wait VR_XS_PCS_DIG_STS bit(4, 2) [PSEQ_STATE] = 100b (Power-Good) 2. write SR_XS_PCS_CTRL2 to select various PCS type 3. write SR_PMA_CTRL1 and/or SR_XS_PCS_CTRL1 for link speed 4. program PMA registers 5. write VR_XS_PCS_DIG_CTRL1 bit(15) [VR_RST] = 1b (Vendor-Specific Soft Reset) 6. wait for VR_XS_PCS_DIG_CTRL1 bit(15) [VR_RST] to get cleared Only 10GBASE-R/SGMII/1000BASE-X modes are planned for the current Wangxun devices. And there is a quirk for Wangxun devices to switch mode although the interface in phylink state has not changed, since PCS will change to default 10GBASE-R when the ethernet driver(txgbe) do LAN reset. Signed-off-by: Jiawen Wu <jiawenwu@trustnetic.com> Signed-off-by: David S. Miller <davem@davemloft.net>
9 lines
311 B
Makefile
9 lines
311 B
Makefile
# SPDX-License-Identifier: GPL-2.0
|
|
# Makefile for Linux PCS drivers
|
|
|
|
pcs_xpcs-$(CONFIG_PCS_XPCS) := pcs-xpcs.o pcs-xpcs-nxp.o pcs-xpcs-wx.o
|
|
|
|
obj-$(CONFIG_PCS_XPCS) += pcs_xpcs.o
|
|
obj-$(CONFIG_PCS_LYNX) += pcs-lynx.o
|
|
obj-$(CONFIG_PCS_MTK_LYNXI) += pcs-mtk-lynxi.o
|
|
obj-$(CONFIG_PCS_RZN1_MIIC) += pcs-rzn1-miic.o
|