linux-stable/Documentation/hwmon/shtc1.rst
Alexander A. Klimov ad736c1a4d hwmon: Replace HTTP links with HTTPS ones
Rationale:
Reduces attack surface on kernel devs opening the links for MITM
as HTTPS traffic is much harder to manipulate.

Deterministic algorithm:
For each file:
  If not .svg:
    For each line:
      If doesn't contain `\bxmlns\b`:
        For each link, `\bhttp://[^# \t\r\n]*(?:\w|/)`:
	  If neither `\bgnu\.org/license`, nor `\bmozilla\.org/MPL\b`:
            If both the HTTP and HTTPS versions
            return 200 OK and serve the same content:
              Replace HTTP with HTTPS.

Signed-off-by: Alexander A. Klimov <grandmaster@al2klimov.de>
Link: https://lore.kernel.org/r/20200719175512.60745-1-grandmaster@al2klimov.de
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
2020-07-24 07:44:57 -07:00

67 lines
1.5 KiB
ReStructuredText

Kernel driver shtc1
===================
Supported chips:
* Sensirion SHTC1
Prefix: 'shtc1'
Addresses scanned: none
Datasheet: https://www.sensirion.com/file/datasheet_shtc1
* Sensirion SHTW1
Prefix: 'shtw1'
Addresses scanned: none
Datasheet: https://www.sensirion.com/file/datasheet_shtw1
* Sensirion SHTC3
Prefix: 'shtc3'
Addresses scanned: none
Datasheet: https://www.sensirion.com/file/datasheet_shtc3
Author:
Johannes Winkelmann <johannes.winkelmann@sensirion.com>
Description
-----------
This driver implements support for the Sensirion SHTC1, SHTW1, and SHTC3
chips, a humidity and temperature sensor. Temperature is measured in degrees
celsius, relative humidity is expressed as a percentage.
The device communicates with the I2C protocol. All sensors are set to I2C
address 0x70. See Documentation/i2c/instantiating-devices.rst for methods to
instantiate the device.
There are two options configurable by means of shtc1_platform_data:
1. blocking (pull the I2C clock line down while performing the measurement) or
non-blocking mode. Blocking mode will guarantee the fastest result but
the I2C bus will be busy during that time. By default, non-blocking mode
is used. Make sure clock-stretching works properly on your device if you
want to use blocking mode.
2. high or low accuracy. High accuracy is used by default and using it is
strongly recommended.
sysfs-Interface
---------------
temp1_input
- temperature input
humidity1_input
- humidity input