linux-stable/arch/powerpc/sysdev/Makefile
Anton Vorontsov 3d64de9c50 powerpc: Implement GPIO driver for simple memory-mapped banks
The driver supports very simple GPIO controllers, that is, when a
controller provides just a 'data' register. Such controllers may be
found in various BCSRs (Board's FPGAs used to control board's
switches, LEDs, chip-selects, Ethernet/USB PHY power, etc).

So far we support only 1-byte GPIO banks. Support for other widths may
be implemented when/if needed.

p.s.
To avoid "made up" compatible entries (like compatible = "simple-gpio"),
boards must call simple_gpiochip_init() to pass the compatible string.

Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2008-12-30 11:13:45 -06:00

52 lines
1.7 KiB
Makefile

ifeq ($(CONFIG_PPC64),y)
EXTRA_CFLAGS += -mno-minimal-toc
endif
mpic-msi-obj-$(CONFIG_PCI_MSI) += mpic_msi.o mpic_u3msi.o mpic_pasemi_msi.o
obj-$(CONFIG_MPIC) += mpic.o $(mpic-msi-obj-y)
fsl-msi-obj-$(CONFIG_PCI_MSI) += fsl_msi.o
obj-$(CONFIG_PPC_MSI_BITMAP) += msi_bitmap.o
obj-$(CONFIG_PPC_MPC106) += grackle.o
obj-$(CONFIG_PPC_DCR_NATIVE) += dcr-low.o
obj-$(CONFIG_PPC_PMI) += pmi.o
obj-$(CONFIG_U3_DART) += dart_iommu.o
obj-$(CONFIG_MMIO_NVRAM) += mmio_nvram.o
obj-$(CONFIG_FSL_SOC) += fsl_soc.o
obj-$(CONFIG_FSL_PCI) += fsl_pci.o $(fsl-msi-obj-y)
obj-$(CONFIG_FSL_LBC) += fsl_lbc.o
obj-$(CONFIG_FSL_GTM) += fsl_gtm.o
obj-$(CONFIG_MPC8xxx_GPIO) += mpc8xxx_gpio.o
obj-$(CONFIG_SIMPLE_GPIO) += simple_gpio.o
obj-$(CONFIG_RAPIDIO) += fsl_rio.o
obj-$(CONFIG_TSI108_BRIDGE) += tsi108_pci.o tsi108_dev.o
obj-$(CONFIG_QUICC_ENGINE) += qe_lib/
obj-$(CONFIG_PPC_BESTCOMM) += bestcomm/
mv64x60-$(CONFIG_PCI) += mv64x60_pci.o
obj-$(CONFIG_MV64X60) += $(mv64x60-y) mv64x60_pic.o mv64x60_dev.o \
mv64x60_udbg.o
obj-$(CONFIG_RTC_DRV_CMOS) += rtc_cmos_setup.o
obj-$(CONFIG_AXON_RAM) += axonram.o
obj-$(CONFIG_PPC_INDIRECT_PCI) += indirect_pci.o
obj-$(CONFIG_PPC_I8259) += i8259.o
obj-$(CONFIG_IPIC) += ipic.o
obj-$(CONFIG_4xx) += uic.o
obj-$(CONFIG_4xx_SOC) += ppc4xx_soc.o
obj-$(CONFIG_XILINX_VIRTEX) += xilinx_intc.o
obj-$(CONFIG_OF_RTC) += of_rtc.o
ifeq ($(CONFIG_PCI),y)
obj-$(CONFIG_4xx) += ppc4xx_pci.o
endif
obj-$(CONFIG_PPC4xx_GPIO) += ppc4xx_gpio.o
obj-$(CONFIG_CPM) += cpm_common.o
obj-$(CONFIG_CPM2) += cpm2.o cpm2_pic.o
obj-$(CONFIG_QUICC_ENGINE) += cpm_common.o
obj-$(CONFIG_PPC_DCR) += dcr.o
obj-$(CONFIG_8xx) += mpc8xx_pic.o cpm1.o
obj-$(CONFIG_UCODE_PATCH) += micropatch.o
ifeq ($(CONFIG_SUSPEND),y)
obj-$(CONFIG_6xx) += 6xx-suspend.o
endif