linux-stable/Documentation/devicetree/bindings/sound/cs35l34.txt
Rob Herring 791d3ef2e1 dt-bindings: remove 'interrupt-parent' from bindings
'interrupt-parent' is often documented as part of define bindings, but
it is really outside the scope of a device binding. It's never required
in a given node as it is often inherited from a parent node. Or it can
be implicit if a parent node is an 'interrupt-controller' node. So
remove it from all the binding files.

Cc: Mark Rutland <mark.rutland@arm.com>
Cc: devicetree@vger.kernel.org
Signed-off-by: Rob Herring <robh@kernel.org>
2018-07-25 14:09:39 -06:00

62 lines
2 KiB
Text

CS35L34 Speaker Amplifier
Required properties:
- compatible : "cirrus,cs35l34"
- reg : the I2C address of the device for I2C.
- VA-supply, VP-supply : power supplies for the device,
as covered in
Documentation/devicetree/bindings/regulator/regulator.txt.
- cirrus,boost-vtge-millivolt : Boost Voltage Value. Configures the boost
converter's output voltage in mV. The range is from VP to 8V with
increments of 100mV.
- cirrus,boost-nanohenry: Inductor value for boost converter. The value is
in nH and they can be values of 1000nH, 1100nH, 1200nH, 1500nH, and 2200nH.
Optional properties:
- reset-gpios: GPIO used to reset the amplifier.
- interrupts : IRQ line info CS35L34.
(See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
for further information relating to interrupt properties)
- cirrus,boost-peak-milliamp : Boost converter peak current limit in mA. The
range starts at 1200mA and goes to a maximum of 3840mA with increments of
80mA. The default value is 2480mA.
- cirrus,i2s-sdinloc : ADSP SDIN I2S channel location. Indicates whether the
received mono data is in the left or right portion of the I2S frame
according to the AD0 pin or directly via this configuration.
0x0 (Default) = Selected by AD0 input (if AD0 = LOW, use left channel),
0x2 = Left,
0x1 = Selected by the inversion of the AD0 input (if AD0 = LOW, use right
channel),
0x3 = Right.
- cirrus,gain-zc-disable: Boolean property. If set, the gain change will take
effect without waiting for a zero cross.
- cirrus,tdm-rising-edge: Boolean property. If set, data is on the rising edge of
SCLK. Otherwise, data is on the falling edge of SCLK.
Example:
cs35l34: cs35l34@40 {
compatible = "cirrus,cs35l34";
reg = <0x40>;
interrupt-parent = <&gpio8>;
interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
reset-gpios = <&gpio 10 0>;
cirrus,boost-vtge-milltvolt = <8000>; /* 8V */
cirrus,boost-ind-nanohenry = <1000>; /* 1uH */
cirrus,boost-peak-milliamp = <3000>; /* 3A */
};