linux-stable/drivers/tty/serial
Erwan Le Ray 4cc0ed626f serial: stm32: add support of timeout interrupt for RX
Add support of RX timeout interrupts to limit the number of interrupts.
RX timeout is a number of bits (baud clock cycles) without
transmission seen in the receiver. One character  is used as an arbitrary
RX timeout value.
If parity is enabled, the number of bits has to include parity bit.

Signed-off-by: Gerald Baeza <gerald.baeza@st.com>
Signed-off-by: Fabrice Gasnier <fabrice.gasnier@st.com>
Signed-off-by: Erwan Le Ray <erwan.leray@st.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2019-06-21 11:17:35 +02:00
..
8250 Revert "serial: 8250: Don't service RX FIFO if interrupts are disabled" 2019-06-21 11:07:34 +02:00
cpm_uart tty: cpm_uart: drop unused iflag macro 2019-05-24 10:09:16 +02:00
jsm tty: add SPDX identifiers to Kconfig and Makefiles 2019-04-04 18:48:43 +02:00
21285.c
altera_jtaguart.c
altera_uart.c
amba-pl010.c
amba-pl011.c tty: amba-pl011: allow shared interrupt 2019-05-21 12:12:03 +02:00
amba-pl011.h
apbuart.c
apbuart.h
ar933x_uart.c serial: ar933x_uart: Fix build failure with disabled console 2019-03-19 15:37:44 +01:00
arc_uart.c
atmel_serial.c tty/serial: atmel: RS485 HD w/DMA: enable RX after TX is stopped 2019-03-28 00:27:48 +09:00
atmel_serial.h tty/serial: atmel: add ISO7816 support 2018-10-02 13:38:55 -07:00
bcm63xx_uart.c
clps711x.c serial: clps711x: Remove board support 2019-01-08 16:55:18 +01:00
digicolor-usart.c tty/serial: digicolor: Fix digicolor-usart already registered warning 2019-06-10 19:08:31 +02:00
dz.c
dz.h
earlycon-arm-semihost.c
earlycon-riscv-sbi.c tty/serial: use uart_console_write in the RISC-V SBL early console 2019-01-23 15:41:50 -08:00
earlycon.c
efm32-uart.c
fsl_lpuart.c serial: fsl_lpuart: Remove unneeded OOM error message 2019-06-18 09:34:28 +02:00
icom.c
icom.h
ifx6x60.c
ifx6x60.h
imx.c serial: imx: fix locking in set_termios() 2019-06-18 09:30:44 +02:00
ioc3_serial.c
ioc4_serial.c
ip22zilog.c
ip22zilog.h
Kconfig tty: serial: add driver for the SiFive UART 2019-04-29 16:30:59 +02:00
kgdb_nmi.c
kgdboc.c Disable kgdboc failed by echo space to /sys/module/kgdboc/parameters/kgdboc 2019-03-28 00:27:48 +09:00
lantiq.c serial: lantiq: Do not swap register read/writes 2019-01-08 16:53:36 +01:00
lpc32xx_hs.c tty: serial: lpc32xx_hs: fix missing console boot messages 2019-01-18 11:23:00 +01:00
Makefile tty: serial: add driver for the SiFive UART 2019-04-29 16:30:59 +02:00
max310x.c Merge 5.2-rc3 into tty-next 2019-06-03 13:53:20 +02:00
max3100.c
mcf.c
men_z135_uart.c drivers: Remove explicit invocations of mmiowb() 2019-04-08 12:01:02 +01:00
meson_uart.c tty: serial: meson: if no alias specified use an available id 2019-01-18 11:22:22 +01:00
milbeaut_usio.c serial: milbeaut_usio: Fix error handling in probe and remove 2019-04-29 16:20:24 +02:00
mpc52xx_uart.c
mps2-uart.c serial: mps2-uart: Add parentheses around conditional in mps2_uart_shutdown 2019-01-31 19:34:10 +01:00
mpsc.c
msm_serial.c tty: serial: msm_serial: avoid system lockup condition 2019-06-10 19:42:35 +02:00
mux.c
mvebu-uart.c serial: mvebu-uart: Fix to avoid a potential NULL pointer dereference 2019-03-19 15:37:43 +01:00
mxs-auart.c tty: mxs-auart: fix a potential NULL pointer dereference 2019-03-19 15:37:43 +01:00
netx-serial.c
omap-serial.c
owl-uart.c
pch_uart.c PCI: Move Rohm Vendor ID to generic list 2019-02-01 17:24:52 -06:00
pic32_uart.c serial: set suppress_bind_attrs flag only if builtin 2018-11-09 09:07:17 -08:00
pic32_uart.h
pmac_zilog.c tty: Use of_node_name_{eq,prefix} for node name comparisons 2018-12-17 16:12:17 +01:00
pmac_zilog.h
pnx8xxx_uart.c
pxa.c
qcom_geni_serial.c tty: serial: qcom_geni_serial: Initialize baud in qcom_geni_console_setup 2019-03-19 15:37:44 +01:00
rda-uart.c tty: serial: Add RDA8810PL UART driver 2018-12-31 13:10:01 -08:00
rp2.c
sa1100.c
samsung.c tty: serial: samsung: Enable baud clock during initialisation 2019-02-19 13:42:08 +01:00
samsung.h
sb1250-duart.c
sc16is7xx.c Merge 5.1-rc6 into tty-next 2019-04-21 23:20:08 +02:00
sccnxp.c serial: sccnxp: Allow to use non-standard baud rates 2018-12-20 16:26:59 +01:00
serial-tegra.c serial: tegra: fix some spelling mistakes 2018-11-09 08:58:18 -08:00
serial_core.c tty: serial_core: Set port active bit in uart_port_activate 2019-06-18 09:52:26 +02:00
serial_ks8695.c
serial_mctrl_gpio.c serial: mctrl_gpio: Check if GPIO property exisits before requesting it 2019-06-21 10:18:43 +02:00
serial_mctrl_gpio.h
serial_txx9.c drivers: Remove explicit invocations of mmiowb() 2019-04-08 12:01:02 +01:00
sh-sci.c serial: sh-sci: disable DMA for uart_console 2019-05-21 12:18:17 +02:00
sh-sci.h
sifive.c tty: serial: add driver for the SiFive UART 2019-04-29 16:30:59 +02:00
sirfsoc_uart.c
sirfsoc_uart.h
sn_console.c tty: fix up a few remaining files without SPDX identifiers 2019-04-04 18:48:43 +02:00
sprd_serial.c serial: sprd: Fix a copy-paste err in sprd_request_dma() 2019-04-16 15:21:33 +02:00
st-asc.c
stm32-usart.c serial: stm32: add support of timeout interrupt for RX 2019-06-21 11:17:35 +02:00
stm32-usart.h serial: stm32: add support of timeout interrupt for RX 2019-06-21 11:17:35 +02:00
suncore.c tty: Use of_node_name_{eq,prefix} for node name comparisons 2018-12-17 16:12:17 +01:00
sunhv.c
sunsab.c
sunsab.h
sunsu.c TTY/Serial driver patches for 4.21-rc1 2018-12-28 20:33:54 -08:00
sunzilog.c
sunzilog.h
tegra-tcu.c serial: Add Tegra Combined UART driver 2019-01-30 09:31:31 +01:00
timbuart.c
timbuart.h
uartlite.c serial-uartlite: fix null pointer dereference on pointer port 2018-11-27 09:08:15 +01:00
ucc_uart.c docs: serial: convert docs to ReST and rename to *.rst 2019-04-25 11:37:42 +02:00
vr41xx_siu.c
vt8500_serial.c
xilinx_uartps.c serial: uartps: Remove useless return from cdns_uart_poll_put_char 2019-06-18 09:34:28 +02:00
zs.c
zs.h