mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2024-09-15 23:25:07 +00:00
2cd3a2a546
There have been various patches floating around for enabling the SDIO IRQ for hsmmc, but none of them ever got merged. Probably the reason for not merging the SDIO interrupt patches has been the lack of wake-up path for SDIO on some omaps that has also needed remuxing the SDIO DAT1 line to a GPIO making the patches complex. This patch adds the minimal SDIO IRQ support to hsmmc for omaps that do have the wake-up path. For those omaps, the DAT1 line need to have the wake-up enable bit set, and the wake-up interrupt is the same as for the MMC controller. This patch has been tested on am3730 es1.2 with mwifiex connected to MMC3 with mwifiex waking to Ethernet traffic from off-idle mode. Note that for omaps that do not have the SDIO wake-up path, this patch will not work for idle modes and further patches for remuxing DAT1 to GPIO are needed. Based on earlier patches [1][2] by David Vrabel <david.vrabel@csr.com>, Steve Sakoman <steve@sakoman.com> For now, only support SDIO interrupt if we are booted with a separate wake-irq configued via device tree. This is because omaps need the wake-irq for idle states, and some omaps need special quirks. And we don't want to add new legacy mux platform init code callbacks any longer as we are moving to DT based booting anyways. To use it, you need to specify the wake-irq using the interrupts-extended property. [1] http://www.sakoman.com/cgi-bin/gitweb.cgi?p=linux.git;a=commitdiff_plain;h=010810d22f6f49ac03da4ba384969432e0320453 [2] http://comments.gmane.org/gmane.linux.kernel.mmc/20446 Acked-by: Balaji T K <balajitk@ti.com> Signed-off-by: Andreas Fenkart <afenkart@gmail.com> Signed-off-by: Tony Lindgren <tony@atomide.com> Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
152 lines
4.6 KiB
C
152 lines
4.6 KiB
C
/*
|
|
* MMC definitions for OMAP2
|
|
*
|
|
* Copyright (C) 2006 Nokia Corporation
|
|
*
|
|
* This program is free software; you can redistribute it and/or modify
|
|
* it under the terms of the GNU General Public License version 2 as
|
|
* published by the Free Software Foundation.
|
|
*/
|
|
|
|
#define OMAP_MMC_MAX_SLOTS 2
|
|
|
|
/*
|
|
* struct omap_mmc_dev_attr.flags possibilities
|
|
*
|
|
* OMAP_HSMMC_SUPPORTS_DUAL_VOLT: Some HSMMC controller instances can
|
|
* operate with either 1.8Vdc or 3.0Vdc card voltages; this flag
|
|
* should be set if this is the case. See for example Section 22.5.3
|
|
* "MMC/SD/SDIO1 Bus Voltage Selection" of the OMAP34xx Multimedia
|
|
* Device Silicon Revision 3.1.x Revision ZR (July 2011) (SWPU223R).
|
|
*
|
|
* OMAP_HSMMC_BROKEN_MULTIBLOCK_READ: Multiple-block read transfers
|
|
* don't work correctly on some MMC controller instances on some
|
|
* OMAP3 SoCs; this flag should be set if this is the case. See
|
|
* for example Advisory 2.1.1.128 "MMC: Multiple Block Read
|
|
* Operation Issue" in _OMAP3530/3525/3515/3503 Silicon Errata_
|
|
* Revision F (October 2010) (SPRZ278F).
|
|
*/
|
|
#define OMAP_HSMMC_SUPPORTS_DUAL_VOLT BIT(0)
|
|
#define OMAP_HSMMC_BROKEN_MULTIBLOCK_READ BIT(1)
|
|
#define OMAP_HSMMC_SWAKEUP_MISSING BIT(2)
|
|
|
|
struct mmc_card;
|
|
|
|
struct omap_mmc_dev_attr {
|
|
u8 flags;
|
|
};
|
|
|
|
struct omap_mmc_platform_data {
|
|
/* back-link to device */
|
|
struct device *dev;
|
|
|
|
/* number of slots per controller */
|
|
unsigned nr_slots:2;
|
|
|
|
/* set if your board has components or wiring that limits the
|
|
* maximum frequency on the MMC bus */
|
|
unsigned int max_freq;
|
|
|
|
/* switch the bus to a new slot */
|
|
int (*switch_slot)(struct device *dev, int slot);
|
|
/* initialize board-specific MMC functionality, can be NULL if
|
|
* not supported */
|
|
int (*init)(struct device *dev);
|
|
void (*cleanup)(struct device *dev);
|
|
void (*shutdown)(struct device *dev);
|
|
|
|
/* To handle board related suspend/resume functionality for MMC */
|
|
int (*suspend)(struct device *dev, int slot);
|
|
int (*resume)(struct device *dev, int slot);
|
|
|
|
/* Return context loss count due to PM states changing */
|
|
int (*get_context_loss_count)(struct device *dev);
|
|
|
|
/* Integrating attributes from the omap_hwmod layer */
|
|
u8 controller_flags;
|
|
|
|
/* Register offset deviation */
|
|
u16 reg_offset;
|
|
|
|
struct omap_mmc_slot_data {
|
|
|
|
/*
|
|
* 4/8 wires and any additional host capabilities
|
|
* need to OR'd all capabilities (ref. linux/mmc/host.h)
|
|
*/
|
|
u8 wires; /* Used for the MMC driver on omap1 and 2420 */
|
|
u32 caps; /* Used for the MMC driver on 2430 and later */
|
|
u32 pm_caps; /* PM capabilities of the mmc */
|
|
|
|
/*
|
|
* nomux means "standard" muxing is wrong on this board, and
|
|
* that board-specific code handled it before common init logic.
|
|
*/
|
|
unsigned nomux:1;
|
|
|
|
/* switch pin can be for card detect (default) or card cover */
|
|
unsigned cover:1;
|
|
|
|
/* use the internal clock */
|
|
unsigned internal_clock:1;
|
|
|
|
/* nonremovable e.g. eMMC */
|
|
unsigned nonremovable:1;
|
|
|
|
/* Try to sleep or power off when possible */
|
|
unsigned power_saving:1;
|
|
|
|
/* If using power_saving and the MMC power is not to go off */
|
|
unsigned no_off:1;
|
|
|
|
/* eMMC does not handle power off when not in sleep state */
|
|
unsigned no_regulator_off_init:1;
|
|
|
|
/* Regulator off remapped to sleep */
|
|
unsigned vcc_aux_disable_is_sleep:1;
|
|
|
|
/* we can put the features above into this variable */
|
|
#define HSMMC_HAS_PBIAS (1 << 0)
|
|
#define HSMMC_HAS_UPDATED_RESET (1 << 1)
|
|
#define HSMMC_HAS_HSPE_SUPPORT (1 << 2)
|
|
#define MMC_OMAP7XX (1 << 3)
|
|
#define MMC_OMAP15XX (1 << 4)
|
|
#define MMC_OMAP16XX (1 << 5)
|
|
unsigned features;
|
|
|
|
int switch_pin; /* gpio (card detect) */
|
|
int gpio_wp; /* gpio (write protect) */
|
|
|
|
int (*set_bus_mode)(struct device *dev, int slot, int bus_mode);
|
|
int (*set_power)(struct device *dev, int slot,
|
|
int power_on, int vdd);
|
|
int (*get_ro)(struct device *dev, int slot);
|
|
void (*remux)(struct device *dev, int slot, int power_on);
|
|
/* Call back before enabling / disabling regulators */
|
|
void (*before_set_reg)(struct device *dev, int slot,
|
|
int power_on, int vdd);
|
|
/* Call back after enabling / disabling regulators */
|
|
void (*after_set_reg)(struct device *dev, int slot,
|
|
int power_on, int vdd);
|
|
/* if we have special card, init it using this callback */
|
|
void (*init_card)(struct mmc_card *card);
|
|
|
|
/* return MMC cover switch state, can be NULL if not supported.
|
|
*
|
|
* possible return values:
|
|
* 0 - closed
|
|
* 1 - open
|
|
*/
|
|
int (*get_cover_state)(struct device *dev, int slot);
|
|
|
|
const char *name;
|
|
u32 ocr_mask;
|
|
|
|
/* Card detection IRQs */
|
|
int card_detect_irq;
|
|
int (*card_detect)(struct device *dev, int slot);
|
|
|
|
unsigned int ban_openended:1;
|
|
|
|
} slots[OMAP_MMC_MAX_SLOTS];
|
|
};
|