mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2024-09-12 21:57:43 +00:00
925089c190
Currently, client devices are created in SBL or AMSS (mission mode) and only destroyed after power down or SYS ERROR. When moving between certain execution environments, such as from SBL to AMSS, no clean-up is required. This presents an issue where SBL-specific channels are left open and client drivers now run in an execution environment where they cannot operate. Fix this by expanding the mhi_destroy_device() to do an execution environment specific clean-up if one is requested. Close the gap and destroy devices in such scenarios that allow SBL client drivers to clean up once device enters mission mode. Signed-off-by: Bhaumik Bhatt <bbhatt@codeaurora.org> Reviewed-by: Loic Poulain <loic.poulain@linaro.org> Reviewed-by: Hemant Kumar <hemantk@codeaurora.org> Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> Link: https://lore.kernel.org/r/1614208985-20851-2-git-send-email-bbhatt@codeaurora.org Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> |
||
|---|---|---|
| .. | ||
| fsl-mc | ||
| mhi | ||
| arm-cci.c | ||
| arm-integrator-lm.c | ||
| brcmstb_gisb.c | ||
| bt1-apb.c | ||
| bt1-axi.c | ||
| da8xx-mstpri.c | ||
| hisi_lpc.c | ||
| imx-weim.c | ||
| Kconfig | ||
| Makefile | ||
| mips_cdmm.c | ||
| moxtet.c | ||
| mvebu-mbus.c | ||
| omap-ocp2scp.c | ||
| omap_l3_noc.c | ||
| omap_l3_noc.h | ||
| omap_l3_smx.c | ||
| omap_l3_smx.h | ||
| qcom-ebi2.c | ||
| simple-pm-bus.c | ||
| sun50i-de2.c | ||
| sunxi-rsb.c | ||
| tegra-aconnect.c | ||
| tegra-gmi.c | ||
| ti-pwmss.c | ||
| ti-sysc.c | ||
| ts-nbus.c | ||
| uniphier-system-bus.c | ||
| vexpress-config.c | ||