linux-stable/drivers/gnss/Kconfig
Johan Hovold d2efbbd18b gnss: add driver for sirfstar-based receivers
Add driver for serial-connected SiRFstar-based GNSS receivers.

These devices typically boot into hibernate mode from which they can be
woken using a pulse on the ON_OFF input pin. Once active, a pulse on the
same ON_OFF pin is used to put the device back into hibernate mode. The
current state can be determined by sampling the WAKEUP output.

Hardware configurations where WAKEUP has been connected to ON_OFF (and
where an initial WAKEUP pulse during boot is sufficient to have the
device boot into active mode) are also supported. In this case, device
power is managed using the main-supply regulator only.

Note that configurations where WAKEUP is left not connected, so that the
device power state can only indirectly be determined using the I/O
interface, is currently not supported. It should be fairly
straight-forward to extend the current implementation with such support
however (and this this is the main reason for not using the generic
serial implementation for this driver).

Note that timepulse-support is left unimplemented.

Signed-off-by: Johan Hovold <johan@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2018-06-28 20:32:51 +09:00

43 lines
943 B
Text

#
# GNSS receiver configuration
#
menuconfig GNSS
tristate "GNSS receiver support"
---help---
Say Y here if you have a GNSS receiver (e.g. a GPS receiver).
To compile this driver as a module, choose M here: the module will
be called gnss.
if GNSS
config GNSS_SERIAL
tristate
config GNSS_SIRF_SERIAL
tristate "SiRFstar GNSS receiver support"
depends on SERIAL_DEV_BUS
---help---
Say Y here if you have a SiRFstar-based GNSS receiver which uses a
serial interface.
To compile this driver as a module, choose M here: the module will
be called gnss-sirf.
If unsure, say N.
config GNSS_UBX_SERIAL
tristate "u-blox GNSS receiver support"
depends on SERIAL_DEV_BUS
select GNSS_SERIAL
---help---
Say Y here if you have a u-blox GNSS receiver which uses a serial
interface.
To compile this driver as a module, choose M here: the module will
be called gnss-ubx.
If unsure, say N.
endif # GNSS