linux-stable/drivers/pci/host/pcie-artpec6.c
Paul Gortmaker 58bdaa1d38 PCI: artpec6: Make explicitly non-modular
This code is not being built as a module by anyone:

  drivers/pci/host/Kconfig:config PCIE_ARTPEC6
  drivers/pci/host/Kconfig:       bool "Axis ARTPEC-6 PCIe controller"

Remove uses of MODULE_DESCRIPTION(), MODULE_AUTHOR(), MODULE_LICENSE(),
etc., so that when reading the driver there is no doubt it is builtin-only.
The information is preserved in comments at the top of the file.

Replace module_platform_driver() with builtin_platform_driver(), which uses
the same init level priority, so init ordering is unchanged.

Note that MODULE_DEVICE_TABLE is a no-op for non-modular code.

[bhelgaas: changelog, add "Author" comment]
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
CC: Niklas Cassel <niklas.cassel@axis.com>
CC: Jesper Nilsson <jesper.nilsson@axis.com>
2016-08-01 12:22:50 -05:00

280 lines
7.2 KiB
C

/*
* PCIe host controller driver for Axis ARTPEC-6 SoC
*
* Author: Niklas Cassel <niklas.cassel@axis.com>
*
* Based on work done by Phil Edworthy <phil@edworthys.org>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/delay.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/pci.h>
#include <linux/platform_device.h>
#include <linux/resource.h>
#include <linux/signal.h>
#include <linux/types.h>
#include <linux/interrupt.h>
#include <linux/mfd/syscon.h>
#include <linux/regmap.h>
#include "pcie-designware.h"
#define to_artpec6_pcie(x) container_of(x, struct artpec6_pcie, pp)
struct artpec6_pcie {
struct pcie_port pp;
struct regmap *regmap;
void __iomem *phy_base;
};
/* PCIe Port Logic registers (memory-mapped) */
#define PL_OFFSET 0x700
#define PCIE_PHY_DEBUG_R0 (PL_OFFSET + 0x28)
#define PCIE_PHY_DEBUG_R1 (PL_OFFSET + 0x2c)
#define MISC_CONTROL_1_OFF (PL_OFFSET + 0x1bc)
#define DBI_RO_WR_EN 1
/* ARTPEC-6 specific registers */
#define PCIECFG 0x18
#define PCIECFG_DBG_OEN (1 << 24)
#define PCIECFG_CORE_RESET_REQ (1 << 21)
#define PCIECFG_LTSSM_ENABLE (1 << 20)
#define PCIECFG_CLKREQ_B (1 << 11)
#define PCIECFG_REFCLK_ENABLE (1 << 10)
#define PCIECFG_PLL_ENABLE (1 << 9)
#define PCIECFG_PCLK_ENABLE (1 << 8)
#define PCIECFG_RISRCREN (1 << 4)
#define PCIECFG_MODE_TX_DRV_EN (1 << 3)
#define PCIECFG_CISRREN (1 << 2)
#define PCIECFG_MACRO_ENABLE (1 << 0)
#define NOCCFG 0x40
#define NOCCFG_ENABLE_CLK_PCIE (1 << 4)
#define NOCCFG_POWER_PCIE_IDLEACK (1 << 3)
#define NOCCFG_POWER_PCIE_IDLE (1 << 2)
#define NOCCFG_POWER_PCIE_IDLEREQ (1 << 1)
#define PHY_STATUS 0x118
#define PHY_COSPLLLOCK (1 << 0)
#define ARTPEC6_CPU_TO_BUS_ADDR 0x0fffffff
static int artpec6_pcie_establish_link(struct pcie_port *pp)
{
struct artpec6_pcie *artpec6_pcie = to_artpec6_pcie(pp);
u32 val;
unsigned int retries;
/* Hold DW core in reset */
regmap_read(artpec6_pcie->regmap, PCIECFG, &val);
val |= PCIECFG_CORE_RESET_REQ;
regmap_write(artpec6_pcie->regmap, PCIECFG, val);
regmap_read(artpec6_pcie->regmap, PCIECFG, &val);
val |= PCIECFG_RISRCREN | /* Receiver term. 50 Ohm */
PCIECFG_MODE_TX_DRV_EN |
PCIECFG_CISRREN | /* Reference clock term. 100 Ohm */
PCIECFG_MACRO_ENABLE;
val |= PCIECFG_REFCLK_ENABLE;
val &= ~PCIECFG_DBG_OEN;
val &= ~PCIECFG_CLKREQ_B;
regmap_write(artpec6_pcie->regmap, PCIECFG, val);
usleep_range(5000, 6000);
regmap_read(artpec6_pcie->regmap, NOCCFG, &val);
val |= NOCCFG_ENABLE_CLK_PCIE;
regmap_write(artpec6_pcie->regmap, NOCCFG, val);
usleep_range(20, 30);
regmap_read(artpec6_pcie->regmap, PCIECFG, &val);
val |= PCIECFG_PCLK_ENABLE | PCIECFG_PLL_ENABLE;
regmap_write(artpec6_pcie->regmap, PCIECFG, val);
usleep_range(6000, 7000);
regmap_read(artpec6_pcie->regmap, NOCCFG, &val);
val &= ~NOCCFG_POWER_PCIE_IDLEREQ;
regmap_write(artpec6_pcie->regmap, NOCCFG, val);
retries = 50;
do {
usleep_range(1000, 2000);
regmap_read(artpec6_pcie->regmap, NOCCFG, &val);
retries--;
} while (retries &&
(val & (NOCCFG_POWER_PCIE_IDLEACK | NOCCFG_POWER_PCIE_IDLE)));
retries = 50;
do {
usleep_range(1000, 2000);
val = readl(artpec6_pcie->phy_base + PHY_STATUS);
retries--;
} while (retries && !(val & PHY_COSPLLLOCK));
/* Take DW core out of reset */
regmap_read(artpec6_pcie->regmap, PCIECFG, &val);
val &= ~PCIECFG_CORE_RESET_REQ;
regmap_write(artpec6_pcie->regmap, PCIECFG, val);
usleep_range(100, 200);
/*
* Enable writing to config regs. This is required as the Synopsys
* driver changes the class code. That register needs DBI write enable.
*/
writel(DBI_RO_WR_EN, pp->dbi_base + MISC_CONTROL_1_OFF);
pp->io_base &= ARTPEC6_CPU_TO_BUS_ADDR;
pp->mem_base &= ARTPEC6_CPU_TO_BUS_ADDR;
pp->cfg0_base &= ARTPEC6_CPU_TO_BUS_ADDR;
pp->cfg1_base &= ARTPEC6_CPU_TO_BUS_ADDR;
/* setup root complex */
dw_pcie_setup_rc(pp);
/* assert LTSSM enable */
regmap_read(artpec6_pcie->regmap, PCIECFG, &val);
val |= PCIECFG_LTSSM_ENABLE;
regmap_write(artpec6_pcie->regmap, PCIECFG, val);
/* check if the link is up or not */
if (!dw_pcie_wait_for_link(pp))
return 0;
dev_dbg(pp->dev, "DEBUG_R0: 0x%08x, DEBUG_R1: 0x%08x\n",
readl(pp->dbi_base + PCIE_PHY_DEBUG_R0),
readl(pp->dbi_base + PCIE_PHY_DEBUG_R1));
return -ETIMEDOUT;
}
static void artpec6_pcie_enable_interrupts(struct pcie_port *pp)
{
if (IS_ENABLED(CONFIG_PCI_MSI))
dw_pcie_msi_init(pp);
}
static void artpec6_pcie_host_init(struct pcie_port *pp)
{
artpec6_pcie_establish_link(pp);
artpec6_pcie_enable_interrupts(pp);
}
static int artpec6_pcie_link_up(struct pcie_port *pp)
{
u32 rc;
/*
* Get status from Synopsys IP
* link is debug bit 36, debug register 1 starts at bit 32
*/
rc = readl(pp->dbi_base + PCIE_PHY_DEBUG_R1) & (0x1 << (36 - 32));
if (rc)
return 1;
return 0;
}
static struct pcie_host_ops artpec6_pcie_host_ops = {
.link_up = artpec6_pcie_link_up,
.host_init = artpec6_pcie_host_init,
};
static irqreturn_t artpec6_pcie_msi_handler(int irq, void *arg)
{
struct pcie_port *pp = arg;
return dw_handle_msi_irq(pp);
}
static int __init artpec6_add_pcie_port(struct pcie_port *pp,
struct platform_device *pdev)
{
int ret;
if (IS_ENABLED(CONFIG_PCI_MSI)) {
pp->msi_irq = platform_get_irq_byname(pdev, "msi");
if (pp->msi_irq <= 0) {
dev_err(&pdev->dev, "failed to get MSI irq\n");
return -ENODEV;
}
ret = devm_request_irq(&pdev->dev, pp->msi_irq,
artpec6_pcie_msi_handler,
IRQF_SHARED | IRQF_NO_THREAD,
"artpec6-pcie-msi", pp);
if (ret) {
dev_err(&pdev->dev, "failed to request MSI irq\n");
return ret;
}
}
pp->root_bus_nr = -1;
pp->ops = &artpec6_pcie_host_ops;
ret = dw_pcie_host_init(pp);
if (ret) {
dev_err(&pdev->dev, "failed to initialize host\n");
return ret;
}
return 0;
}
static int artpec6_pcie_probe(struct platform_device *pdev)
{
struct artpec6_pcie *artpec6_pcie;
struct pcie_port *pp;
struct resource *dbi_base;
struct resource *phy_base;
int ret;
artpec6_pcie = devm_kzalloc(&pdev->dev, sizeof(*artpec6_pcie),
GFP_KERNEL);
if (!artpec6_pcie)
return -ENOMEM;
pp = &artpec6_pcie->pp;
pp->dev = &pdev->dev;
dbi_base = platform_get_resource_byname(pdev, IORESOURCE_MEM, "dbi");
pp->dbi_base = devm_ioremap_resource(&pdev->dev, dbi_base);
if (IS_ERR(pp->dbi_base))
return PTR_ERR(pp->dbi_base);
phy_base = platform_get_resource_byname(pdev, IORESOURCE_MEM, "phy");
artpec6_pcie->phy_base = devm_ioremap_resource(&pdev->dev, phy_base);
if (IS_ERR(artpec6_pcie->phy_base))
return PTR_ERR(artpec6_pcie->phy_base);
artpec6_pcie->regmap =
syscon_regmap_lookup_by_phandle(pdev->dev.of_node,
"axis,syscon-pcie");
if (IS_ERR(artpec6_pcie->regmap))
return PTR_ERR(artpec6_pcie->regmap);
ret = artpec6_add_pcie_port(pp, pdev);
if (ret < 0)
return ret;
platform_set_drvdata(pdev, artpec6_pcie);
return 0;
}
static const struct of_device_id artpec6_pcie_of_match[] = {
{ .compatible = "axis,artpec6-pcie", },
{},
};
static struct platform_driver artpec6_pcie_driver = {
.probe = artpec6_pcie_probe,
.driver = {
.name = "artpec6-pcie",
.of_match_table = artpec6_pcie_of_match,
},
};
builtin_platform_driver(artpec6_pcie_driver);