The service can use the snapshotter directly to get the rootfs.
Removed debug line for mount response.
Signed-off-by: Derek McGowan <derek@mcgstyle.net> (github: dmcgowan)
The message was defined but the method was returning empty, plumb through the
result from the shim layer.
Compile tested only.
Signed-off-by: Ian Campbell <ian.campbell@docker.com>
To make restarting after failed pull less racy, we define `Truncate(size
int64) error` on `content.Writer` for the zero offset. Truncating a
writer will dump any existing data and digest state and start from the
beginning. All subsequent writes will start from the zero offset.
For the service, we support this by defining the behavior for a write
that changes the offset. To keep this narrow, we only support writes out
of order at the offset 0, which causes the writer to dump existing data
and reset the local hash.
This makes restarting failed pulls much smoother when there was a
previously encountered error and the source doesn't support arbitrary
seeks or reads at arbitrary offsets. By allowing this to be done while
holding the write lock on a ref, we can restart the full download
without causing a race condition.
Once we implement seeking on the `io.Reader` returned by the fetcher,
this will be less useful, but it is good to ensure that our protocol
properly supports this use case for when streaming is the only option.
Signed-off-by: Stephen J Day <stephen.day@docker.com>
Allow deletion of content over the GRPC interface. For now, we are going
with a model that conducts reference management outside of the content
store, in the metadata store but this design is valid either way.
Signed-off-by: Stephen J Day <stephen.day@docker.com>
For clients which only want to know about one container this is simpler than
searching the result of execution.List.
Signed-off-by: Ian Campbell <ian.campbell@docker.com>
After implementing pull, a few changes are required to the content store
interface to make sure that the implementation works smoothly.
Specifically, we work to make sure the predeclaration path for digests
works the same between remote and local writers. Before, we were
hesitent to require the the size and digest up front, but it became
clear that having this provided significant benefit.
There are also several cleanups related to naming. We now call the
expected digest `Expected` consistently across the board and `Total` is
used to mark the expected size.
This whole effort comes together to provide a very smooth status
reporting workflow for image pull and push. This will be more obvious
when the bulk of pull code lands.
There are a few other changes to make `content.WriteBlob` more broadly
useful. In accordance with addition for predeclaring expected size when
getting a `Writer`, `WriteBlob` now supports this fully. It will also
resume downloads if provided an `io.Seeker` or `io.ReaderAt`. Coupled
with the `httpReadSeeker` from `docker/distribution`, we should only be
a lines of code away from resumable downloads.
Signed-off-by: Stephen J Day <stephen.day@docker.com>
Signed-off-by: Michael Crosby <crosbymichael@gmail.com>
Add registration for more subsystems via plugins
Signed-off-by: Michael Crosby <crosbymichael@gmail.com>
Move content service to separate package
Signed-off-by: Michael Crosby <crosbymichael@gmail.com>
