(mnt,mnt_mountpoint) pair is conceptually wrong; if you want
to use it for generating pathname and for nothing else *and*
if you know that vfsmount tree is unchanging, you can get
away with that, but the right solution for that is (mnt,mnt_root).
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
The handling of mount flags in set_mnt_shared() got a little tangled
up during previous cleanups, with the following problems:
* MNT_PNODE_MASK is defined as a literal constant when it should be a
bitwise xor of other MNT_* flags
* set_mnt_shared() clears and then sets MNT_SHARED (part of MNT_PNODE_MASK)
* MNT_PNODE_MASK could use a comment in mount.h
* MNT_PNODE_MASK is a terrible name, change to MNT_SHARED_MASK
This patch fixes these problems.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
No one is calling this anymore as everyone has switched to
invalidate_mapping_pages long time ago. Also update a few
references to it in comments. nfs has two more, but I can't
easily figure what they are actually referring to, so I left
them as-is.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
re-order structure super_block to remove 16 bytes of alignment padding
on 64bit builds.
This shrinks the size of super_block from 712 to 696 bytes so requiring
one fewer 64 byte cache lines.
Signed-off-by: Richard Kennedy <richard@rsk.demon.co.uk>
-----
patch against 2.6.33-rc5
compiled & tested on x86_64 AMDX2 desktop machine.
I've been running with this patch applied for several weeks with no
problems.
regards
Richard
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
path to mnt/mnt->mnt_root is no worse than that to
mnt->mnt_parent/mnt->mnt_mountpoint *and* needs no
pinning the sucker down (mnt is not going away and
mnt->mnt_root won't change)
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
* document locking
* add the missing part of data structure invariants (relationship
between mnt_share and mnt_slave lists in case of a peer group
among slaves).
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
First of all, get_source() never results in CL_PROPAGATION
alone. We either get CL_MAKE_SHARED (for the continuation
of peer group) or CL_SLAVE (slave that is not shared) or both
(beginning of peer group among slaves). Massage the code to
make that explicit, kill CL_PROPAGATION test in clone_mnt()
(nothing sets CL_MAKE_SHARED without CL_PROPAGATION and in
clone_mnt() we are checking CL_PROPAGATION after we'd found
that there's no CL_SLAVE, so the check for CL_MAKE_SHARED
would do just as well).
Fix comments, while we are at it...
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Invalidate sb->s_bdev on remount,ro.
Fixes a problem reported by Jorge Boncompte who is seeing corruption
trying to snapshot a minix filesystem image. Some filesystems modify
their metadata via a path other than the bdev buffer cache (eg. they may
use a private linear mapping for their metadata, or implement directories
in pagecache, etc). Also, file data modifications usually go to the bdev
via their own mappings.
These updates are not coherent with buffercache IO (eg. via /dev/bdev)
and never have been. However there could be a reasonable expectation that
after a mount -oremount,ro operation then the buffercache should
subsequently be coherent with previous filesystem modifications.
So invalidate the bdev mappings on a remount,ro operation to provide a
coherency point.
The problem was exposed when we switched the old rd to brd because old rd
didn't really function like a normal block device and updates to rd via
mappings other than the buffercache would still end up going into its
buffercache. But the same problem has always affected other "normal"
block devices, including loop.
[akpm@linux-foundation.org: repair comment layout]
Reported-by: "Jorge Boncompte [DTI2]" <jorge@dti2.net>
Tested-by: "Jorge Boncompte [DTI2]" <jorge@dti2.net>
Signed-off-by: Nick Piggin <npiggin@suse.de>
Cc: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Cleanup EXPORT* macros according to Documantation/CodingStyle.
Move EXPORT* macros to the line immediately after the closing
function brace.
Signed-off-by: H Hartley Sweeten <hsweeten@visionengravers.com>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
EXPORT_SYMBOL(proc_symlink);
EXPORT_SYMBOL(proc_mkdir);
EXPORT_SYMBOL(create_proc_entry);
EXPORT_SYMBOL(proc_create_data);
EXPORT_SYMBOL(remove_proc_entry);
Those EXPORT_SYMBOL shouldn't be in fs/proc/root.c,
should be in fs/proc/generic.c.
Signed-off-by: Helight.Xu <helight.xu@gmail.com>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Remove the EXPORT_UNUSED_SYMBOL of simple_prepare_write
Collapse simple_prepare_write into it's only caller, though
making it simpler and clearer to understand.
Signed-off-by: Boaz Harrosh <bharrosh@panasas.com>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
* simple_commit_write was only called by simple_write_end.
Open coding it makes it tiny bit less heavy on the arithmetic and
much more readable.
* While at it use zero_user() for clearing a partial page.
* While at it add a docbook comment for simple_write_end.
Signed-off-by: Boaz Harrosh <bharrosh@panasas.com>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
This reverts commit 213614d583.
Alas, ->d_revalidate() can't rely on ->lookup() finishing what
it's started; if d_alloc() in do_lookup() fails, we are not going
to call ->lookup() at all.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Set the PCI CLS early in the boot process to prevent
device failures. In pcibios_set_master use the new
pci_cache_line_size instead of a hard-coded value.
Signed-off-by: Carlos O'Donell <carlos@codesourcery.com>
Reviewed-by: Grant Grundler <grundler@google.com>
Signed-off-by: Kyle McMartin <kyle@redhat.com>
Trailing semicolon causes compilation involving out_le32() to fail.
Signed-off-by: Steven J. Magnani <steve@digidescorp.com>
Signed-off-by: Michal Simek <monstr@monstr.eu>
I create wrong asm code but none test shows that this part of code is wrong.
I am not convinces that were good idea to create asm optimized macros
for caches. The reason is that there is not optimization with previous code
that's why make sense to add old code and do some benchmarking which
functions are faster.
Signed-off-by: Michal Simek <monstr@monstr.eu>
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6:
net: bug fix for vlan + gro issue
tc35815: Remove a wrong netif_wake_queue() call which triggers BUG_ON
cdc_ether: new PID for Ericsson C3607w to the whitelist (resubmit)
IPv6: better document max_addresses parameter
MAINTAINERS: update mv643xx_eth maintenance status
e1000: Fix DMA mapping error handling on RX
iwlwifi: sanity check before counting number of tfds can be free
iwlwifi: error checking for number of tfds in queue
iwlwifi: set HT flags after channel in rxon
Traffic (tcp) doesnot start on a vlan interface when gro is enabled.
Even the tcp handshake was not taking place.
This is because, the eth_type_trans call before the netif_receive_skb
in napi_gro_finish() resets the skb->dev to napi->dev from the previously
set vlan netdev interface. This causes the ip_route_input to drop the
incoming packet considering it as a packet coming from a martian source.
I could repro this on 2.6.32.7 (stable) and 2.6.33-rc7.
With this fix, the traffic starts and the test runs fine on both vlan
and non-vlan interfaces.
CC: Herbert Xu <herbert@gondor.apana.org.au>
CC: Patrick McHardy <kaber@trash.net>
Signed-off-by: Ajit Khaparde <ajitk@serverengines.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/lenb/linux-acpi-2.6:
ACPI: Be in TS_POLLING state during mwait based C-state entry
ACPI: Fix regression where _PPC is not read at boot even when ignore_ppc=0
acer-wmi: Respect current backlight level when loading
* 'drm-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6:
drm/vmwgfx: Fix queries if no dma buffer thrashing is occuring.
drm/nv50: fix vram ptes on IGPs to point at stolen system memory
drm/nv50: fix instmem binding on IGPs to point at stolen system memory
drm/nv50: improve vram page table construction
drm/nv50: more efficient clearing of gpu page table entries
drm/nv50: make nv50_mem_vm_{bind,unbind} operate only on vram
drm/nouveau: Fix up pre-nv17 analog load detection.
Revert the change made to arch/ia64/sn/kernel/setup.c by commit
204fba4aa3 as it breaks the build.
Fixing the build the b94b08081f way
breaks xpc because genksyms then fails to generate an CRC for
per_cpu____sn_cnodeid_to_nasid because of limitations in the
generic genksyms code.
Signed-off-by: Hedi Berriche <hedi@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
The netif_wake_queue() is called correctly (i.e. only on !txfull
condition) from txdone routine. So Unconditional call to the
netif_wake_queue() here is wrong. This might cause calling of
start_xmit routine on txfull state and trigger BUG_ON.
This bug does not happen when NAPI disabled. After txdone there
must be at least one free tx slot. But with NAPI, this is not
true anymore and the BUG_ON can hits on heavy load.
In this driver NAPI was enabled on 2.6.33-rc1 so this is
regression from 2.6.32 kernel.
Reported-by: Ralf Roesch <ralf.roesch@rw-gmbh.de>
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch adds a new vid/pid to the cdc_ether whitelist.
Device added:
- Ericsson Mobile Broadband variant C3607w
Signed-off-by: Torgny Johansson <torgny.johansson@gmail.com>
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Signed-off-by: David S. Miller <davem@davemloft.net>
Andrew Morton wrote:
>> >From ip-sysctl.txt file in kernel documentation I can see following description
>> for max_addresses:
>> max_addresses - INTEGER
>> Number of maximum addresses per interface. 0 disables limitation.
>> It is recommended not set too large value (or 0) because it would
>> be too easy way to crash kernel to allow to create too much of
>> autoconfigured addresses.
^^^^^^^^^^^^^^
>> If this parameter applies only for auto-configured IP addressed, please state
>> it more clearly in docs or rename the parameter to show that it refers to
>> auto-configuration.
It did mention autoconfigured in the text, but the below makes it more obvious.
More clearly document IPv6 max_addresses parameter.
Signed-off-by: Brian Haley <brian.haley@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Check for error return from pci_map_single/pci_map_page and clean up.
With this and the previous patch the driver was able to handle a significant
percentage of errors (I set the fault injection rate to 10% and could still
download large files at a reasonable speed).
Signed-off-by: Anton Blanchard <anton@samba.org>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This reverts commit fb1e75389b.
"Benjamin S." <sbenni@gmx.de> reports that the patch in question
causes a big drop in sequential throughput for him, dropping from
200MB/sec down to only 70MB/sec.
Needs to be investigated more fully, for now lets just revert the
offending commit.
Conflicts:
include/linux/blkdev.h
Signed-off-by: Jens Axboe <jens.axboe@oracle.com>
Intercept query commands and apply relocations to their guest pointers.
Signed-off-by: Thomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
